Linsar 214L User manual

LINSAR
Callus Remover
214L
TEG 12620
ORIGINAL OPERATING INSTRUCTIONS

Table of contents
General ......................…............………....………....3
Explanation of symbols ........…..........…..............4
Safety .....…………................................................5
Scope of delivery / parts ..............………….........12
First time use………………...................................13
Check article and scope of delivery................14
Inserting or replacing batteries....……………….14
Selecting roller head .................................…...14
Attaching and removing the roller head…..…...15
Attaching the roller head ...................…...….…16
Removing the roller head ................….........…16
How to use the callus remover ........………....….17
Cleaning ..............................….....................…...19
Storage ..................................………..…….......….20
Troubleshooting ..........................................…..21
Declaration of Conformity ........................……..22
Technical data ....................................………......22
Replacing the roller head .............................….23
Disposal ...................................................………23
Warranty ....................................................……24
Warranty / Order form

3
General remarks
Read and keep the opera�ng instruc�ons
Read the opera�ng instruc�ons
carefully, especially the safety
instruc�ons, before using this appliance.
Failure to follow these opera�ng instruc�ons may
result in serious injury or property damage.
Keep these opera�ng instruc�ons for further use.
If you pass this appliance on to someone else,
make sure to include these opera�ng
instruc�ons.

4
Symbols explained
The following symbols and key terms are used in
these opera�ng instruc�ons, on the ar�cle itself,
or on the packaging.
This symbol indicates a hazard with
a medium level of risk, which, if
not avoided, could result in a
in
death or serious injury.
This symbol indicates a hazard with a
low level of risk, which, if not
avoided, may result in minor or
moderate injuries.
This term warns of possible material
damage.
This icon gives access to useful addi�onal
informa�on.
NOTE!
WARNING！
CAUTION!

5
Declara�on of conformity (see chapter
"Declara�on of conformity"): Products
marked with this symbol meet the
requirements of the EC direc�ves.
SYMBOLS.docx
Safety
Intended use
The device is designed exclusively for removing
calluses from feet, hands, elbows and knees.
It is intended for private use only and not suitable for
commercial use.
Only use the device as described in these opera�ng
instruc�ons.Any other use is considered improper
and may result in material damage or even personal
injury.
This item is not a toy.
The manufacturer or dealer accepts no liability for
damage caused by improper or incorrect use.

6
Safety instruc�ons
Hazardous for children and
persons with reduced physical,
sensory or mental abili�es (for
example, disabled persons, elderlypersons with
reduced physical and mental abili�es) or lack of
experience and knowledge (for example, older
children).
This device can be used by children aged 8 years
and above and persons with reduced physical,
sensory or mental capabili�es or lack of experience
and knowledge, if they are supervised or have been
instructed in the safe use of the device and
understand the hazards involved.
Children may not play with the device.
Children may not use this product, clean it or carry
out maintenance.
Keep the item away from children.
Do not let children play with the packaging foil.
They can get caught while playing and
suffocate.
WARNING!

7
Risk of injury!
Improper handling of this item may result in injury.
Use only for calluses on feet, hands, elbows and
knees.
Use only on dry calluses. Do not moisten, or use
creams or oil on the callus.
Use only for the removal of calluses. Do not use on
soor tender patches of skin.
The device must not be applied to:
-wounds, or near wounds.
-skin areas injured for any reason, such as acid
or burns.
-ined or sore skin areas.
Do not use the arcle to remove warts.
Do not apply to one area of skin for more than 2
to 3 seconds.
Stop applying immediately if experiencing pain or
skin irritaon.
In case of bleeding from treated skin or persistent
skin irritaon, consult a doctor immediately.
Do not use the item if it is damaged or the roller
head is worn out.
CAUTION!

8
Risk of injury due to rapidly
rota�ng parts!
The head roller rotates at high
speed during use. There is a risk of injury, or
damage to the arcle, if the roller gets caught in
hair or clothing.
Keep hair, clothing, etc. away from the roller
head.
Risk of damage!
Improper handling may result in damaging the
device.
Do not immerse in water or any other liquid.
Store the device so that it cannot fall into a tub or
sink.
Before aaching the roller head to the handle,
make sure that there are no foreign parts or
contaminants between the roller head and the
handle.
Do not drop, expose to extreme temperatures,
direct sunlight or vibraon.
Only operate the switch on the handle with the
roller head in place.
NOTE!
CAUTION!

9
Before changing the roller head, switch othe
device.
If there are changes in normal working, e.g.
strong vibran, unusual operang noise or
smoke, switch othe device immediately.
Only use original accessories.
Do not open the housing and do not make any
changes to the device.
Baery informaon
Danger of explosion and burns!
If baeries are handled
improperly, there is a risk of
explosion or chemical burns due to leaking baery
uid.
Do not expose baeries to strong heat, and do
not throw them into open re.
Always replace all baeries at the same me, and
only with baeries of the same type.
WARNING!

10
Do not short circuit or disassemble the baeries.
Never aempt charging with non-rechargeable
baeries.
Avoid contact of baery uid with skin, eyes and
mucous membranes.
Do not remove baery uid with bare hands.
In case of contact with the baery uid,
immediately rinse the aected areas with plenty
of water and seek medical aenon.
If you plan not to use the item for a  remove
the baeries.
Remove and dispose of used baeries
immediately and properly.
Keep the baeries away from children.
If baeries are swallowed or otherwise enter the
body, seek medical aenmediately.

11
Front Back

12
Scope of delivery / device parts
1 Protecve cover
2 Roller head with extra coarse grain (Pink)
3 Roller head with coarse grain (Purple)
4 On/Oswitch
5 Locking push buon On/Oswitch
6 Cleaning brush
7 Locking buon for roller head.
8 LED
9 Baery compartment cover
10 Baery compartment
- 2 baeries 1.5 V size AA (type LR6)
- Original user manual incl. Warranty

13
First-�me use
Before first use, ask your doctor:
- whether the applica�on is indicated in
case of exis�ng medical disorders, such as allergies,
skin rash, skin irrita�on, eczema, scaly skin, diabetes,
circulatory disorder, etc.
- whether the applica�on is suitable for a wearer of
a pacemaker.
- whether using this device makes sense in your
case.
Check the ar�cle and scope of delivery
Risk of damage!
Be careful when opening the package with a knife
or similar.
- Open the packaging carefully.
1. Take the item out of the packaging and check
whether the item or the individual partsshow any
damage. If this is the case, do not use it. Contact the
manufacturer via the service address indicated on
the Warranty.
NOTE
!

14
We recommend keeping the original packaging for
later storage.
2. Check if all items are included.
Inserting or replacing ba�eries
1. Open the baery compartment cover (9) and
insert 2 AA/LR6 baeries (included) as shown at the
base of the baery compartment boom.
When replacing the baeries, remove the
used baeries rst.
2.Close the baery compartment cover (9).
Selecting a roller head
Included are 2 roller heads with dierent
rollers - coarse and extra coarse. Use the
following table to select the roller head that
is suitable for the intended applican.

15
Roller head with:
Applicaon for:
Extra coarse
grain (Pink)
Very rough and thicker
calluses.
Coarse grain
(Purple)
Normal calluses, and aer
applying the roller head
with the extra coarse grit.
Aer each applicaon with extra coarse grit,
carry out a short aer-treatment with the
coarse roller to render the skin smooth again.
Aaching and removing the roller head
Risk of damage!
Aaching or removing the roller head while the unit
is switched on can damage the arcle.
- Before aaching or removing the roller head,
switch using on/ switch (4).
NOTE!

16
A�aching the roller head
1.Press the roller
head onto the
handle as shown,
unl it audibly
clicks into place.
2.Check that the
roller head is 
aached.
Removing the
roller head
1.Press the locking
buon(7) and
reove the roller
head frothe
n unit.

17
How to use the callus remover
-Take some e and, especially if you are using
the item for the st me, proceed with
cauon.
-Perform each applicaon without applying
pressure to the skin area.
-Take frequent short breaks and check the
result.
-If necessary, change the roller head.
-This item should not be used by more than one
person to avoid transming disease.
1. Clean aected skin
area and dry
thoroughly.
2. Select roller head
3 (coarse or extra
coarse) and aach it
to the handle.
If needed, remove
the protecve cover
(1).

18
3. Press the locking buon for the on/oswitch (5)
and push the on/oswitch (4) upwards.
The LED (8) lights up during use.
The LED also serves to light up the skin area
being treated.
4. Place the roller on the area to be treated and
move it across the callus. Stop the procedure aer 2
to 3 seconds and examine the result. Repeat the
treatment un you are saed with the result.
5. Aer nishing the treatment, switch  the
arcle by sliding the on/oswitch (5) downwards.
6. Clean the arcle aer each use; see under
Cleaning.

19
Cleaning
Clean the item a�er each use.
NOTE! Danger of short circuit!
Water or liquid entering the interior of the device
may cause a short circuit.
- Do not immerse or rinse the device in water or any
other liquid.
NOTE! Risk of damage!
If the item is not cleaned properly, it may be
damaged.
-Do not use aggressive cleaning agents, brushes
with metal or nylon bristles, or sharp or
metallic cleaning objects such as knives and the
like.
-Clean roller head without using liquids.
1. Remove the roller head and tap it out in the sink.

20
2. Wipe  skin residues with a dry cloth.
3. Use the brush (6) to remove skin residue from all
parts. The roller can be rotated for cleaning.
Storage
Store the arcle and its accessories in a dry,
frost-free place, and out of the reach of children.
Remove the baeries when not in use for a longer
period.