Liquid Ears LEBSFBK Operating instructions

Battery Charge:
This Wireless Earphone is powered by a rechargeable Li-ion battery.
When the battery is low the earphones will emit a sound to remind you to recharge it.
1. Insert USB charging cable into a suitable USB port for charging.
2. Connect the USB charging cable with the Micro USB port to the earphone.
3. The LED indicator turns red to show battery is charging.
4. The LED indicator turns off when battery is fully charged.
5. It takes about 2 hours to fully charge the earphone.
How to use this Earphone:
A. Power ON/OFF
B. Pairing the Earphone
1. To enter pairing mode ensure earphone is OFF. To ensure the earphones are ready for pairing, press
and hold the power button (1) for 5 seconds until the LED indicator flashes blue and red, and
an audio tone can be heard.
2. On your device, search for the pairing name: LE Secure Fit.
Once connected a single tone can be heard for successful pairing.
LED indicator turns blue and the earphone
plays an audio tone for power on mode
Power ON Press and hold the power
button (1) for 3 seconds
Power OFF Press and hold the power
button (1) for 3 seconds
LED indicator flashes red, then goes out
and earphone plays an audio tone for power
off mode
Function Operation LED indicator
WIRELESS
EARPHONES
LEBSFBK, LEBSFLG, LEBSFRG
Specifications:
Driver Size: 10mm
Impedance: 32 Ohm ±15%
Sensitivity: 93dB ± 3dB at 1kHz
Frequency Response: 20Hz - 20kHz
Wireless Range: 10m
Play Time: 4 Hours
Battery Size: 55mAh
Charge Time: 2 Hours
Included:
1 x Wireless Earphone
1 x USB to Micro USB Charging Cable
2 x Small Ear Cushions
2 x Medium Ear Cushions
2 x Large Ear Cushions

1702/
7
Function Operation
Pause Press button (1)
Play Press button (1)
Next Song Press button (5)
Previous Song Press button (6)
Volume Up Press and hold button (5)
When the volume is
adjusted to maximum you
will hear an indication tone
Volume Down Press and hold button (6)
Answer Call Press button (1)
End Call Press button (1)
Reject Call Press and hold button (1)
Call Last Number Double press button (1)
Overview:
1. Power/Play/Pause button
2. Micro USB charging port
3. LED indicator
4. Built-in microphone
5. Skip forward track/press and hold volume up
6. Skip backward track/press and hold volume down
Continuous use at full output may damage hearing.
Liquid Ears is a registered trademark.
Liquid Ears™
PO Box 5658 Brendale QLD Australia 4500
Customer Support 1800 812 261
www.liquidears.com
DESIGNED IN AUSTRALIA
1.
6.
2.
4.
3.
5.
NOTE: Not all devices support all the functions
listed above. Please refer to your device’s user
manual for further information.