Litelink ACC-1008 User manual

WARRANTY
All fiber optic transmission systems, products and accessories
manufactured by Liteway, Inc. and it’s subsidiaries are fully tested prior
to shipment and are warranted against defective materials and
workmanship for a period of five full years from the date of the original
shipment. Should a problem occur, a Return Material Authorization
Number (RMA) must be obtained from Liteway Inc. at [phone]
and the item returned to Liteway, Inc. 166 Haverford Road, Hicksville,
NY 11801, USA, prepaid. Liteway Inc. will then, at its option repair or
replace the defective item.
Liteway, Inc. maximum liability under this warranty is limited to the cost
of the defective item only. No contingent liabilities of any kind are either
assumed or implied.
Any items returned to Liteway, Inc. that have been misused, abused,
damaged, modified, connected or adjusted in any way contrary to the
instructions furnished by Liteway, Inc. or repaired by unauthorized
personnel will not be covered by this warranty. Any non-warranty
repairs required will be quoted at the current rate for such services.
Important Notices
CAUTION ! AVOID DIRECT EXPOSURE TO BEAM.
All -7,-8, and -9 Models use laser diodes. These solid-state laser diodes
are located in the optical ports of these units. Laser diodes produce
invisible radiation that may be harmful to human eyes. Never look
directly into the optical port of any fiber optic unit designed to operate
with single-mode optical fiber.
NOT FOR LIFE SUPPORT SYSTEMS
Liteway, Inc. does not authorize or warrant any of its products or
accessories for use in critical life support systems or applications of any
kind.
© Copyright 2017 Liteway, Inc. 136020 Rev C
OPERATING INSTRUCTIONS
ACC-1008 In-line Volume Control
For use with ACC-1004
Amplified Speaker and
INCX-4001 Intercom station
The ACC-1008 external in-line volume control can be used to
adjust the volume between an INCX-4001 Intercom station and
an ACC-1004 amplified speaker when the levels are too high
for the normal range of volume from the INCX-4001.
Installation is as follows:
!

3.5mm Plug to
INCX-4001 3.5mm Jack to ACC-1004
In-line Volume
control
5 feet
(approx) 1 foot
(approx)
136020 Rev C
Operating Instructions
1. Set the switch on the volume control unit to the “ST” or
“MON” position depending on the degree of attenuation
required.
2. Connect the 90 degree plug on the ACC-1008 to the remote
speaker jack inside the INCX-4001 Intercom Unit.
3. Connect the plug from the ACC-1004 amplified speaker to
the jack on the ACC-1008 volume control.
4. Adjust the volume control for the desired output volume.
5. The external clip provided may be used to secure the volume
control near the ACC-1004 (on the other cables) if required.