Litelink ACC-1015 User manual
WARRANTY
All fiber optic transmission systems, products and accessories
manufactured by Liteway, Inc. and it’s subsidiaries are fully tested
prior to shipment and are warranted against defective materials
and workmanship for a period of five full years from the date of the
original shipment. Should a problem occur, a Return Material
Authorization Number (RMA) must be obtained from Liteway Inc.
at (516) 931-2800 and the item returned to Liteway, Inc. 166
Haverford Road, Hicksville, NY 11801, USA, prepaid. Liteway Inc.
will then, at its option repair or replace the defective item.
Liteway, Inc. maximum liability under this warranty is limited to the
cost of the defective item only. No contingent liabilities of any kind
are either assumed or implied.
Any items returned to Liteway, Inc. that have been misused,
abused, damaged, modified, connected or adjusted in any way
contrary to the instructions furnished by Liteway, Inc. or repaired
by unauthorized personnel will not be covered by this warranty.
Any non-warranty repairs required will be quoted at the current
rate for such services.
Important Notices
NOT FOR LIFE SUPPORT SYSTEMS
Liteway, Inc. does not authorize or warrant any of its products or
accessories for use in critical life support systems or applications
of any kind.
© Copyright 2017 Liteway, Inc. 135840 Rev C
OPERATING INSTRUCTIONS
Litelink®Desk-to-Microphone
Model ACC-1015
The Litelink®Model ACC-1015 is an omni-directional electret type
desktop microphone designed to be used with the INCX-4001
intercom. It is of a "gooseneck" design allowing the microphone end
to be oriented as desired by the user. The ACC-1015 plugs directly
into the INCX-4001.
!
Technical Specifications
Audio Bandwidth 60 Hz to 12 KHz
Sensitivity 6.0 mV/Pa @ 1 KHz
Impedance 1K ohms
Maximum SPL 120 dB
Operating Power Provided by the INCX-4001
Temperature range 0 to 50 degrees, C
All specifications are subject to change without prior notice.
135840 Rev C
Operating Instructions
1. Install red jumper strip into microphone jack on INCX-
40001 circuit board.
2. Plug microphone into Headset connector on INCX-
4001.
3. For momentary talk operation press the Talk button on
the microphone base.
4. For continuous talk operation press the Lock button on
the microphone base. To revert back to momentary
operation press the Lock button again.
For best results use the attached wind screen
