
Instruction manual
5
INSTRUCTIONS FOR USE
Follow these instructions carefully to avoi seriously amaging your barbecue an causing injury to
yourself an to property.
1. Assemble the barbecue following the assembly instructions carefully.
2. Connect the gas hose to the barbecue. Connect the regulator to the hose.
3. Connect the regulator to the cylin er valve following the regulator instructions supplie with the
regulator.
4. Turn all of the control knobs to the ‘OFF’ position before turning on the gas supply to the appliance.
5. Operate the regulator in accor ance with the instructions supplie with the regulator.
LIGHTING INSTR CTIONS: MAIN B RNERS
1. Connect the gas cylin er to the barbecue following the instructions supplie with the regulator.
2. Turn all the control knobs to the ‘OFF’ position.
3. Turn ‘ON’ the gas supply at the cylin er or regulator switch following the regulator connection an
operating instructions. Check the cylin er to regulator connection an hose to barbecue hose inlet
connection for leakage using soapy water. Any leakage will show as bubbles in the area of the leak. If
leak is foun , o not use the barbecue an turn off the gas supply. Consult your gas or barbecue
supplier for a vice.
4. Before ignition, open the li if there is .To light the left han burner, push own an turn the left burner
control knob anticlockwise to the 90° position (Full rate position). An au ible click will be hear , this
shoul light the burner. Check that the burner is alight. If the burner has not lit, repeat this process.
5. If the burner has not lit after two attempts, turn ‘OFF’ the gas tap an wait 5 minutes before retrying
the ignition sequence.
6. When the burner has lit, the burner rate can be a juste by turning the knob anticlockwise to any
position between the full an low rate positions.
7. Light the remaining burners from left to right in sequence.
8. To switch on the right burner, press on the right button quite there the turning point counter clockwise
up to the position " big flame " ( full power), at the same time quickly press on the button of ignition
(situate between both buttons) 4 times in succession. This will switch on the right burner. If it oes
not work repeat the operation.
9. If the burner oes not ignite after 2 tries, cut the gas inlet by turning the button on "Stop" an wait 5
minutes before re-trying to to switch on it.
10. If the burner oes not remain switche on, repeat the stage 8.
11. When the burner is switche on. A just the power by turning the button to the positions " small flame
" or the " big flame " .re- trying to switch on it.
12. To switch off the plancha, cut the gas inlet by turning the button of the valve or the regulator in position
"Stop", by following the instructions supplie with the regulator. Turn the buttons of all the burners in
the irections of watch han s, in position "Stop" switche off,(fa e ), when flames are switche off.