Instruction manual
8
Always use fresh water before starting ice production either at initial installation or after a long shut-off
period.
DANGER
It is normal for the compressor and condenser surface to reach temperatures between 70°C and
90°C during operation and surrounding areas may be very hot.
CL ANING AND MAINT NANC
This chapter provides you with important notices with regard to cleaning and maintaining the device.
Please observe the notices to prevent damages due to cleaning the device incorrectly and to ensure
trouble-free operation.
•Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequently. When
cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to
clean the inside and the outside surface of the Ice maker. Do not spray Ice maker with chemicals or
diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.
•If the compressor stops for any reason such as water shortage, too much Ice, power off, etc... Do
not start the system right away, wait 3 minutes, and then re-start the Ice maker.
•Always use fresh water before starting ice production either at initial installation or after a long
shut-off period.
Troub eshooting
1. Please note, if a power failure occurs due to disconnection of the power cord, or the off power
button has been pushed off during an ice making cycle, small ice chips may formed and lodge in the
automatic shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting the
power cord and gently pushing the shovel to the rear of the cabinet and removing the ice chips,
then restarting.
2. If the Ice shovel does not push the Ice into the Ice collector while at the same time the IC light is
on, check to see if the water tray is horizontal or balanced. If not then adjust by pressing the Ice
shovel lightly with your finger. Then re-start the Ice maker.
Possible Cause Suggested Solutions
