Livoo DOM454 User manual

Instruction manual
WWW.LIVOO.FR
Reference : DOM454
Version : 1.4
Language : English
Ice ma er

Instruction manual
1
You have purchased a product LIVOO brand and we than you. We ta e great care in design, ergonomics
and ease of use of our products. We hope that this product will give you complete satisfaction.
This instruction manual is available too on our website www.livoo.fr
SAFETY ADVICES
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USING
THE APPLIANCE AND SAVE IT FOR ANY FURTHER NEED.
1. Read all instructions before using.
2. Unplug the machine before fitting, removing, or cleaning
parts.
3. Ensure the voltage is compliant with the voltage range
stated on the rating label, and ensure the earthing of the
soc et is in good condition.
4. Children should not use this machine unsupervised. Do not
let the cord hang down where a child could grab it.
5. This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lac of experience and nowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the
hazards involved.
6. Cleaning and user maintenance shall not be made by
children without supervision
7. Children shall not play with the appliance
8. Do not use it outdoors. Keep it away from sources of heat,

Instruction manual
2
direct sunlight, humidity (never dip it into any liquid) and
sharp edges.
9. Do not use the appliance with wet hands. If the appliance is
humid or wet, unplug it immediately.
10. Keep the appliance and its cord out of reach of children less
than 8 years.
11. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard(*)
12. To protect against the ris of fire, electric shoc , or personal
injury, do not place the cord, plug, or unit in water or other
liquids.
13. The appliance must be placed on a flat and stable surface.
14. Never leave the machine on unattended.
15. Always ma e sure everything is thoroughly clean before
ma ing ice cube.
16. Never clean with scouring powders or hard implements.
17. The appliance is not intended to be operated by means of
external timer or separate remote control system.
18. Do not upend this product or incline it over a 45° angle.
19. Do not use the accessories which are not recommended by
manufacturer.
20. Do not switch on the power button frequently (ensure
5min. interval at least) to avoid the damage of compressor.
21. Metal sheet or other electric objects are not allowed to be
inserted into the appliance to avoid fire and short circuit.
22. Warning: Do not store explosive substances such as aerosol

Instruction manual
3
cans with a flammable propellant in this appliance.
23. Children aged from 3 to 8 years are allowed to load and
unload refrigerating appliances.
24. WARNING: when positioning the appliance, ensure the
supply cord is not trapped or damaged.
25. WARNING: do not locate multiple portable soc et outlets or
portable power supplies at the rear of the appliance.
26. This appliance is intended to be used in household and
similar applications such as:
•staff itchen areas in shops, offices and other
wor ing environments
•farm houses
•by clients in hotels, motels and other
residential type environments
•bed and brea fast type environments
(*)
Competent qualified electrician: after sales department of the producer or importer or any person who
is qualified, approved and competent to perform this ind of repairs in order to avoid all danger. In any
case you should return the appliance to this electrician.
SPECIAL MEASURES
Warning; Ris of fire / flammable materials
- Keep the appliance 8cm from other objects to ensure the
good heat releasing.

Instruction manual
4
- WARNING – Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear of obstruction.
- WARNING - Do not use mechanical devices or other means to
accelerate the defrosting process, other than those
recommended by the manufacturer.
- WARNING - Do not damage the refrigerant circuit.
- WARNING - Do not use electrical appliances inside the food
storage compartments of the appliance, unless they are of the
type recommended by the manufacturer
- WARNING - fill with potable water only.
- Pure water is not allowed to be used on this unit, spring water
is recommended.
- Only use drin ing water without additives! Additives remain
in the water circuit and contaminate the appliance.
- Opening the door for long periods can cause a significant
increase of the temperature in the compartments of the
appliance.
- Clean regularly surfaces that can come in contact with food
and accessible drainage systems.
- Clean water tan s if they have not been used for 48 h; flush
the water system connected to a water supply if water has not
been drawn for 5 days.
- If the refrigerating appliance is left empty for long periods,
switch off, defrost, clean, dry, and leave the door open to
prevent mould developing within the appliance.

Instruction manual
5
PREPARATION BEFORE USE.
Remove all pac ing material and carefully chec your ice ma er to ensure it is in good condition and that
there is no damage to the ice ma er or power cord and plug.
IMPORTANT: Please observe a waiting period of 6 hours before initial operation and after moving the
appliance for the refrigerant to settle; otherwise the compressor can be damaged.
SPECIFICATIONS
Cooling R600a (31g)
Water Reservoir Capacity: 2.6L Liters
Voltage: AC220-240V 50Hz
Power: 150 Watts 1.2A
DESCRIPTION
1. Buttons
2. Control panel
3. Top Cover
4. Transparent lid
5. Micro switch brac et
6. Evaporator
7. Water box
8. Ice shovel board
9. Ice Bas et
10. Water Reservoir
11. ventilation grids
11

Instruction manual
6
PANEL
• : Plug in the power and the source indicator flashes. Press the POWER button, the power
indicator light is always on, the machine will start the de-icing function first, then the ice bloc will
be automatically produced according to the selected mode. After the ice-ma ing is completed, the
ice will be removed, and then the ice-scraping function will be entered.
•MODE: Select the ice size mode. The default is the big ice production mode. The production time of
small ice is 8 minutes and 30 seconds, and the production time of big ice is 9 minutes and 30 seconds.
•NETTOYAGE (CLEAN): Press the cleaning button, the motor start wor ing, and then water pump will
start draw water, repeat the cycle about 4 minutes, and the machine will stop wor ing.
•SMALL: small ice selecti n
• LARGE big ice selecti n
•ADD WATER: Water shortage alarm: When this red is on, it means there is water shortage in
the water tan . You need to add water and press the POWER button to restart the machine.
•ICE FULL ice alarm: When the ice reaches the maximum amount of ice storage container,
the “ICE FULL” light flashes and the machine stops. At this time, the ice needs to be poured out.
When the ice position is lower than the full sensor position, the machine automatically restart.
USE

Instruction manual
7
Bef re/First use f y ur Ice Maker
1. During transportation, the incline angle of the cabinet should not be over 45°. Do not turn the ice ma er
upside down. As this may damage the compressor and sealed system.
2. Remove all pac ing material and carefully chec your ice ma er to ensure it is in good condition and that
there is no damage to the ice ma er or power cord and plug.
3. The Ice ma er should be placed horizontally on a level surface. To ensure proper ventilation for your Ice
ma er allow 150 mm of space at the top, the bac and on each side. Do not install the Ice ma er near
an oven, radiator, or any other heat source.
4. Before using the Ice ma er for the first time, please wait 2 hours after positioning it, and eep the front
lid open for at least 2hours.
5. Ensure that the voltage indicated on the ice ma er corresponds with the voltage in your home.
6. Pure water is not allowed to be used on this unit, spring water is recommended.
Operating Instructi ns
1. Open the lid and fill the water reservoir with water.
N te: Make sure the water level in the water reserv ir n t exceed the MAX p siti n.
2. Connect to the power. Select the size of the ice you want to ma e, default big ice.
NOTE: When the ind r temperature is l wer than 15 degrees, please ch se small ice. When the ind r
temperature is higher than 30 degrees, it is rec mmended t ch se big ice.
3. Press button to turn unit on. The ice ma er begins to wor .
N te: F r the first three cycles, the ice may be small and irregular in size.
4. If indicator is red, then ta e out the bas et, then add water as per step 1，then press to
restart the ice ma er
5. If indicator is in red with 'BIP' noise, please ta e out the ice with the scoop.
N te: When the ice c llecting tray is full please rem ve the ice immediately, d n t all w the ice
c llecting tray t verfill.
6. Press ON/OFF button to stop the machine.
7. If no water is pumped up to the water tray over two cycles but the water in water tan is enough,
then please move the unit ahead a little, then remove the silicon stopper, and let several drops water
runs out.

Instruction manual
8
Due to fast freezing, ice cubes may appear “Cloudy”. This is air trapped in the water and will not affect
quality or taste of ice.
WARNING
If the icema er is reused after a long time, the water pump may not pump sufficient water due to an air
bloc , the deficient water indicator turns on in this case. To correct this press the START button again,
then the icema er will wor normally.
To ensure the cleanliness of the ice cubes, water in the water reservoir should be replaced every
24 hours.
Always use fresh water before starting ice production either at initial installation or after a long shut-off
period.
DANGER
It is normal for the compressor and condenser surface to reach temperatures between 70°C and
90°C during operation and surrounding areas may be very hot.
CLEANING AND MAINTENANCE
This chapter provides you important notices regarding cleaning and maintaining the device.
Please observe the notices to prevent damages due to cleaning the device incorrectly and to ensure
trouble-free operation.
•Clean the ice collecting tray, water box, ice shovel and evaporator frequently. When cleaning,
unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the
inside and the outside surface of the Ice ma er. Do not spray Ice ma er with chemicals or diluted
agents such as acids, gasoline or oil. Rinse thoroughly before starting.
•If the compressor stops for any reason such as water shortage, too much Ice, power off, etc... Do
not start the system right away, wait 3 minutes, and then re-start the Ice ma er.
•Always use fresh water before starting ice production either at initial installation or after a long
shut-off period.
Tr ublesh ting
1. Please note, if a power failure occurs due to disconnection of the power cord, or the off power
button has been pushed off during an ice ma ing cycle, small ice chips may formed and lodge in the
automatic shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting the
power cord and gently pushing the shovel to the rear of the cabinet and removing the ice chips,
then restarting.
2. If the Ice shovel does not push the Ice into the Ice collector while at the same time the ICE light is
on, chec to see if the water tray is horizontal or balanced. If not then adjust by pressing the Ice

Instruction manual
9
shovel lightly with your finger. Then re-start the Ice ma er.
Problem
Possible Cause Suggested Solutions
The compressor wor s
abnormally with a Buzzing
noise
The voltage is lower than
recommended
Stop the Ice ma er and do not restart
until the voltage is normal.
Water shortage indicator
light is on
1.There is no water
2.The pump is full of air
1. Press the ON/OFF button, fill with
water, wait 3 minutes and press the
start button to restart. When the
water has reached the fill line the ice
ma er will restart automatically.
2. Remove the silicon stopper and let
several drops water runs out.
Indicator lights on display
are not on
Blown fuse/ No power Replace fuse / Turn power on
The Ice made is too large
and with pieces stic ing
together.
the outside temperature
is too low or the water
inside tan is too cold
1.Stop the unit right away, restart the
unit till the ice in water tray melt
down
2.Fill in the water tan with room
temperature
Conditions for Ice ma ing
Cycle are right but no ice is
made.
A. There is no refrigerant
in the compressor
B. Compressor is bro en
down
C. Fan motor is bro en
call for service
The lights of ice full and
deficient come at in the
same time.
Water tray is bloc ed by
ice cube
Clear the ice cube under the ice
shovel pull out the plug and insert It
again then press the ”ON/OFF”
button, two minutes later the
machine will restart automatically
Water lea age at front
bottom of the unit
The silicon stopper is not
well inserted
Please insert the silicon stopper well