Ljusdesign neo FRESNEL 2 User manual
neo
FRESNEL
USER MANUAL
Contents
Mounting on track 3
Operational features 4
Settings 5
Barn doors attatchment 6
Lighting design 7
2016-10-09 Rev A02
2
3
Put the luminare in the track.
Lock the side lock.
Lock the adapter lock by pushing until it clicks.
Mounting on track
4
Pan and tilt lock makes it possible to target and lock the device in a fixed position.
The luminare can be rotated 365 degrees and be locked with the pan lock.
1. Loosen the tilt knob.
2. Tilt the fixture.
3. Tighten the tilt knob.
1. Loosen the pan lock knob.
2. Rotate the fixture.
3. Tighten the pan lock knob.
The tilting is limited from 0 to 93 degrees,
further tilting can result in the lock being
damaged.
Operational features
Tilt locking
Pan lock
Tilt angle
5
Adjust the brightness with
the potentiometer.
Set up the phase [3 . 1 . 2]
The dots symbolizes ”off”
Settings
Phase selector
Dimmer
6
Barn doors attachment
Press together the barn doors with your hand
and push it into the front of the luminiare.
The barn doors is now attached
and can be rotated.
Make sure all four latches are in place. If
necessary, use a small flat blade screwdriver
and push them in place.
(If you ever need to remove the barn doors,
gently bend up the latches.)
7
Lighting design
Adjust beam angle with the
focus knob by turning it.
You can adjust edge
sharpness and/or colour
temperature by applying
filter.
Use barn doors to control
the light even further.
Beam angle
Sharpness/Colour
Control
Södra Skeppsbron 4, 802 80, Gävle, Sweden
Questions?Keep in touch!
Table of contents
