Lobo Commander 601TC User manual

Dog Training Collar with Wireless Remote
Quick Start Guide
lobocommander.com

Copyright ©2014 Lobo Commander. All Rights Reserved.
For complete user manual, training guides
and instructional video, please visit
WWW. LOBOCOMMANDER.COM
Experiencing diculty with your training collar?
Don’t panic! Call our customer support team at
1-844-243-4346
or email us at [e-mail]

Charging Collar and Remote
Please charge the collar and the remote before rst use. For both remote and collar, full
charge takes approximate 3 hrs. Please DO NOT overcharge units as it may cause
damage.
When charging the remote, the battery icon on the remotes screen will ash as the
unit charges. Charging is complete when the icon becomes solid.
When charging the collar, the red LED will ash as the collar charges. Charging is complete
once the LED turns o.

Syncing Collar and Remote
If the collar for any reason loses connectivity with the remote, simply reset the collar by lifting
the rubber cover over the charging port of the collar. There is a small hole next to the charging
port. Insert the end of a paper clip or any similar item in the hole.This will cause the red LED
to ash slowly. Now press either the collar tone, shock, or vibrate button on the remote. This
will cause the red LED on the collar to ash quickly. The remote and collar are now properly
connected. Be sure to replace the rubber cover over the charging port.
Collar Top View
Charging Port
Reset

Sleep Mode
Both the collar and the remote have an automatic sleep mode to conserve battery life.
The remote will enter sleep mode after there is no activity for one and a half minutes. To
awaken the remote, simply give the power button or the programming button
a quick press.
The collar will enter sleep mode if the collar does not sense any movement for one minute.
The collar will awaken once any movement is detected.
1 4

Remote Operation
MENU
Power Button
1
Collar Tone Button
2
Shock Button
3
Vibrate Button
5
Remote Tone Button
6
Menu / Mode Button
4

Power Button - Press and hold button down for 2-3 seconds to turn on/o remote.
Quickly press button to awaken remote from sleep mode.
Collar Tone Button - Press button to cause the collar to produce an audible tone. The
tone will continue to sound as long as the button is pressed. When the remote is in
programming mode, this button is used to lower the settings being programmed.
Shock Button - Press the button to cause the collar to deliver a shock through the
metal prongs. The shock will continue as long as the button is pressed.
Menu / Mode Button - Press and hold button down for 2-3 seconds to put the remote
into programming mode. Repeat to exit programming mode. . A quick press of the
button will change the collar mode from A, B, or A&B. Once in programming mode, a
quick press of the button will scroll through the features to be programmed.
Remote Tone Button - Press the button to cause the remote to produce a tone. The
tone will continue to sound as long as the button is pressed. When the remote is in
programming mode, this button is used to raise the settings being programmed.
Vibrate Button - Press the button to cause the collar to vibrate. The vibration will
continue as long as the button is pressed.

lobocommander.com
TM
Warranty Registration
To register your training collar
for the Limited Lifetime Warranty,
please visit WWW.LOBOCOMMANDER.COM
and claim your FREE GIFT!