LOBSTER SPORTS EL20 Setup guide

Replacing and Installing a New Remote Control (EL20/EL21)
Repair Instructions
Elite Models that Apply: Elite Liberty-EL05LE
Step
Description
Tools
Picture
1
Open The control panel by unscrewing the (4) Phillips-head
screws in each corner of the control panel.
Phillips
Screw
Driver
Control Panel - Closed
2
Gently pull the control panel out and allow it to rest below
the opening in the red case.
Control Panel - Open
3
Remove the protective backing from the adhesive side of
the Velcro strip. Place the remote control receiver against
the right side of the metal box (Ball Guide) just inside the
opening in the red case.
Velcro Adhesive (Back of
Receiver)
4
Press the remote control receiver firmly against the Ball
Chute with the single antenna wire facing forward and the
wire connector to the rear.
Receiver Installed
5
Attach the wire harness connector from the remote control
receiver to the back of the green electronic board (PCB
board) in the pins labeled “J22” (EL01-EL03 models) or “Remote”
(EL04-EL05LE models)
Remote Receiver Connected to
Control Panel

Replacing and Installing a New Remote Control (EL20/EL21)
Repair Instructions
Replacement Remote Controls:
EL20 2-Function Wireless Remote Control
E578 Transmitter (Key Fob)
E579 Receiver
EL21 20-Function Wireless Remote Control
E583.1 Transmitter (Controller)
E582.2 Receiver
6
Ensure all wires are connected and reattach the control
panel to the red case using the (4) Phillips-head screws.
Take extra caution to feed all wires into the case and ensure
No wires are trapped between the control panel and the
red case.
Phillips
Screw
Driver
Control Panel - Closed
7
Turn on machine. Turn remote switch on control panel to
“ON”. Test the Feed and SWEEP functions using the transmitter.
Special Note: There will be a 20 second delay from the time
the machine is turned on before the remote functions become
active.