Locstar EM 4102 User manual

www.locstar.com
O
OO
Operation manaul
peration manaul peration manaul
peration manaul
Technical data
Technical dataTechnical data
Technical data
Card type:EM 4102 card
Read distance ：≤3CM
Work current：Direct current 6V，four pieces AA battery
Static consumption：≤15 uA
Dynamic consumption：300 mA
Work temperature：0℃～70℃
Resist static：＞15000V
Low battery alarm：4.8±0.2，
Door thickness requirement ：35-50MM。
Operation step
Operation stepOperation step
Operation step
1
11
1、
、、
、Set master card
Set master cardSet master card
Set master card
Approach any of new card to the installed new lock,the short buzzer ring refer to master
card has been set successfully.
Clean master card:Press reset button and at the same time approach any of card didn’t
set in this lock before,the long buzzer ring refer to the master card has been re-set
successfully.
2.Set unlocking card.
2.Set unlocking card.2.Set unlocking card.
2.Set unlocking card.
Approach master card in front of lock with a long buzzer ring goes to the condition of
setting unlocking card.During the green ligh flash ,introduce any of ID card ,which didn’t
set in the lock before,refer to the main unlocking card has been set successfully with
short buzzer ring.The setting condition will finish within 5 seconds if there is no next card
set
Approach master card in front of lock with a short buzzer goes in to the condition of
setting main unlocking card.Approach master card again within 5 seconds during the
green ligh flash goes in to condition of setting assistant unlocking card.Approach any
of new ID card to set assistand unlocking card with short buzzer ring.The condtion of
Reset
button
8012
reset
button

www.locstar.com
setting assistand unlocking card will finish with the finishing of red light flash If there is no
next card to set
3.
3.3.
3.Unlocking
UnlockingUnlocking
Unlocking：
：：
：
Approach any of main unlocking card or assistant card to unlock door.
4.Automatic locking
4.Automatic locking4.Automatic locking
4.Automatic locking
Put any of card which did n’t setting in the lock.Lock will be automatic locked.(with five minutes
there is no any response for any card)
5.Set normal unlocking con
5.Set normal unlocking con5.Set normal unlocking con
5.Set normal unlocking condition
ditiondition
dition
Approach any of main unlocking card in front of lock twice to set normal unlocking
condition.Approach the main unlocking card again to cancel normal unlocking condition
Approach any of unlocking card to cancel normal unlocking condition.
6.
6.6.
6.Clean inf
Clean infClean inf
Clean information in lock
ormation in lockormation in lock
ormation in lock
In the condition of setting assistand unlocking card,put the master card again.All the
information in the lock will be cleaned with a long buzzer.The lock recover to the condition of
factory.
7.Low voltage alarm
7.Low voltage alarm7.Low voltage alarm
7.Low voltage alarm
When the voltage is lower than alarm voltage ,approach unlocking card in front of lock ,there will
a buzzer ring three times with red light flash ,then green light on.Turn handle ,door open.Please
change battery as soon as possible
8.Emergency unlocking
8.Emergency unlocking8.Emergency unlocking
8.Emergency unlocking：
：：
：
Use mechanical key
Use mechanical keyUse mechanical key
Use mechanical key to unlock in emergecy .
to unlock in emergecy . to unlock in emergecy .
to unlock in emergecy .