
GB-10
Connecting The Transmitter (main viewing room, e�g� sitting room)
5� Plug the supplied 3�5mm to RCA cable into the A/V IN socket on
the transmitter and then plug into the SCART output socket on
your AV source device (e�g� satellite receiver, VCR or DVD player)�
**Optional: Alternatively you may also use the supplied
SCART OUT RCA adapter (Transmitter)�
6� Plug the IR remote extender cable into the IR remote extender
socket on the transmitter�
7� Position the IR remote extender cable in front of the IR sensor
window of your AV source device (e�g� satellite receiver, VCR or
DVD player)�
8� Connect the remaining power adapter to the power adapter
socket on the transmitter and then plug the power adapter into
the mains socket�
9� Both the transmitter and receiver have a Channel Select / OFF
switch� Ensure that the same Channel / OFF switch on both the
transmitter and receiver are set to the same channel A, B, C�
10� Select an appropriate AV channel on the receiving TV� The TV
should now show whatever signal the transmitter is sending
and if the IR remote extender cable is properly positioned, you
will be able to control the AV source by pointing the correct
remote control at the IR remote extender on top / in front of
your TV�
Logik_LAVSEN10_101130.indd 10 11/30/10 11:14 AM