4
KEY TO SYMBOLS
For your own safety, read through the entire
user manual carefully and do not start the ma-
chine before you have understood everything.
Use approved ear protectors and protective
eyewear. Hearing can be damaged even after
short periods of exposure.
Rotating saw chain. Make sure that your n-
gers never move into the vicinity of the guide
bar. Never reach over the guide rail. Never
touch the Speed Saw when it is running.
This symbol means ’WARNINg’. Pay particular
attention where this symbol appears in the
manual text.
A warning comes after this symbol. Pay par-
ticular attention where this symbol appears in
the manual text.
• Read the entire user manual carefully before
using the electric saw. Risk of mortal danger if
you do not follow the safety instructions.
• LOGOSOL E8 Speed Saw is exclusively intended
for rip sawing with the LOGOSOL Sawmill.
Improper use can cause serious injury. Always be
concentrated and careful when using this saw
unit.
• Fit support legs under the guide rail before
pushing the saw unit onto the sawmill.
Otherwise the LOGOSOL Sawmill will tip over,
unless there is no load on the log beds.
• Always make sure that the saw unit is pushed
fully into position on the guide rail before
connecting the power cable. If not all four
plastic proles clutches the guide rail anges,
there is risk of the saw unit being thrown out
when started.
• Make sure that the power cable can run freely
over the entire sawmill length. Never step on the
cable. The power cable should be suspended by
a wire above the sawmill.
• The eleectric saw together with the LOGOSOL
Sawmill is a one-man sawmill. Respect the
safety distance due to high noise level and risk
of a broken chain being hurled out from the
guide bar.
• Turn the saw unit off after each saw cut.
• Never work alone and make sure there are other
persons within earshot whom you can summon
if you need help.
• Always wear protective clothing and use
personal protective equipment: Close-tting
work overalls are appropriate. Never operate the
unit wearing loose-tting clothes, overall coats
or similar.
• Use safety shoes with high-grip soles and steel
toecaps. Neckerchiefs, ties, jewellery or other
items that can get caught in the equipment are
not to be worn.
• Never stretch over or under the Logosol
sawmill’s guide rail when the sawmill is in
operation. Rotating saw chain. Risk of cut
injuries! The saw chain and other rotating parts
are accessible on the guide bar side, underneath
the saw unit on the operator side, and in the
sawdust duct.
• Wear strong protective gloves. Risk of cut
injuries when handling the guide bar and the
saw chain. Cutting equipment can also be hot
immediately after sawing.
• Never leave the saw unattended with the power
cable connected so that unauthorized persons
can start it.
• After service, the machine should be returned
to its original condition. Only use original spare
parts.
• Always disconnect the power before:
...changing guide bar and chain.
...adjusting, cleaning or other servicing.
...touching the moving parts of the saw unit.
...lifting the saw unit off the LOGOSOL Sawmill.
safety instructions
Hearing can be damaged after relatively
short periods of exposure to the high
frequency noise of the motor and the
cutting equipment.
