Loof Bed Pure User manual

Bed Pure
Assembly manual

Content of the box
Plastic leg
1x
Support plate
8x
Bed hook
8x
Rubber pad
6x
Bedside
2x
Foot end
1x
Middle beam
1x
Head end
1x

Connector housing
16x
Joint connector
8x
Euro-Screw
32x
Screw 16mm
8x
Screw 20mm
4x Dowel 60mm
2x
________________________________________________________________________________
Optional headboard
Headboard bracket
2x
Headboard
1x
________________________________________________________________________________
Needed for assembling
ScrewdriverAllen key

1.
1.1
1.2
1.3
1.1 Insert the connector housing 16x into the round holes on top of the bedsides -
make sure the arrow is pointing to the hole.
1.2 Attach the support plate 8x to the frame with the Euro-screw 32x.
1.3 Insert the joint connector 8x into the holes at the ends of the bedsides.
Assembly

2.
3.
2.1 Connect the four bedsides.
2.2 Tighten by turning the connector housing 8x to the right with the allen key - only 3/4
turn needed.
To avoid the bed base from sliding, stick the rubber pad 6x
to the bed hook 6x.

4.
4.1 Insert the plastic leg 1x into the middle beam.
4.2 Attach the bed hook 2x to the middle beam with the 20mm screw 4x.
4.2
5.
To achieve the desired height of your mattress, hook the bed hook 6x into the
support plate 6x on the level of your choice. Do the same with the middle beam but
please note the beam has to be hooked one level below the other bed hooks.

6.
Please note: when there’s too much empty space between the bed bases and the bed-
frame you can put the dowel 60 mm 2x into the holes in the middle beam. To enable a
xed position for the bed bases.
Turn the plastic leg 1x to the left to extend it and give it the desired length.
7.

Assembly headboard
1.
2.
Mount the metal bracket 2x on the bed head end using the screw 16mm.
Mount the headboard on the metal brackets of the bed using the screw 16mm.

NEED SOME HELP?
[email protected] / [phone]