LOVE THE DRIVE Love The Wind Wind Deflector User manual

We have our video install guides on
our website and on youtube.com also
feel free to call or email us if you
have any questions 1-855-457-5683
[email protected]
Start by putting your top down. Have a friend help you install the wind deflector
the first few times. After that, you will easily be able to install and remove on your own.
Step 1: When your wind
deflector was shipped to
you the front brackets
had to be lowered to fit
into the box. You need
to remove the top two
screws using a #2
philips (This is a very
common screw driver
and the end of the screw
looks like an X)Do not
remove the bottom
screw.
Swing the top bracket into the 'up'
position and then replace the two
screws. Now do this to the other
side. This will only need to be done
one time when you first receive
your wind deflector.

Step 3 Cont: The front brackets fit
into the space behind the hole where
the seat belt comes out of. The
brackets are designed not to interfere
with the seat belt.
Step 3 Cont: Insert the front bracket on the
opposite side from where you are standing first.
Then place the bracket into the hole on your
side. Remember to continue holding the back of
the wind deflector.
Step 2: Remove the four straps attached
to the wind deflector. There are two
straps with black snap hooks and two with
silver hooks.
Step 3: Stand on one side of your car so
you are in line with the back seat. A friend
can stand on the other side to help.

Step 5: Now attach the two black snap
hooks to the baby seat anchors. There are
four of these anchors in the back seat.
Attach the two snap hooks to the middle
anchors by the seat belt buckles.
Step 5 Cont: The black snap hooks are
inserted with the snap facing down. Slide the
hook into the hole, press down and then pull
back towards you to attach it to the anchor.
Step 6 Cont: Next attach the four straps. The
two black snap hook straps attach near the back
brackets and the two silver hook straps attach to
the buckle under the front brackets.
Step 6: The
front silver hook
straps attach to
the bottom of
the trim panel
below the back
seats. Attach
the silver hooks
on both sides.
Step 4 Cont: The rear brackets may
need to be adjusted so they fit tight
against the trim panel. The adjustment is
made by adjusting the two screws
underneath the wind defelctor.

If you have any questions or comments please
call 1-855-457-5683 or email [e-mail]
www.lovethedrive.com
Step 6 Cont: Once you have attached all
four buckles, go back and pull down on
each strap to tighten. From now on if
you remove the wind deflector you can
just undo the buckles and leave the
straps in place.
Step 7: Your wind deflector is designed to fit in
the trunk when not in use. Please make sure that
you insert the wind deflector with the front
brackets facing out.
PLEASE NOTE: If you try to put the wind
deflector in your trunk with the front brackets
facing the wrong way (frontwards) it will not fit
properly. If you do manage to get it in, it will be
very difficult to remove.