LPD Furniture ANTOINETTE 3 DRAWER CHEST User manual

ANTOINETTE 3 DRAWER CHEST
ASSEMBLY INSTRUCTIONS
Page 1 of 3
IMPORTANT
PLEASE READ BEFORE YOU CONTINUE FURTHER
THE PRODUCT YOU HAVE PURCHASED WILL GIVE YOU MANY YEARS OF SERVICE IF YOU FOLLOW THE GUIDELINES FOR
ITS SAFE ASSEMBLY AND PERIODIC MAINTENANCE AND CLEANING ...
DO NOT USE ANY TOOLS OTHER THAN THOSE SHOWN.
ASSEMBLE ON A SOFT CLEAN SURFACE.
ANY SPANNERS ON ALLEN KEYS REQUIRED ARE INCLUDED WITH THE FITTINGS KIT.
DO NOT FOR ANY REASON USE A POWER TOOL TO ASSEMBLE THIS PRODUCT. ITS USE WILL INVALIDATE ANY CLAIM
YOU
MAY HAVE AND COULD MAKE THIS PRODUCT UNSAFE.
DEPENDING ON THE AMOUNT OF USE THIS PRODUCT RECEIVES IT MAY BE NECESSARY TO TIGHTEN UP THE FIXINGS
FROM TIME TO TIME. THIS IS COMPLETELY NORMAL FOR ANY FLAT PACK FURNITURE.
FOR CLEANING YOU MAY USE A DAMP CLOTH (NOT WET) OR DRY DUSTER.
DO NOT USE ABRASIVE OR CHEMICAL CLEANERS AS THESE COULD SCRATCH OR DAMAGE THE SURFACE OF YOUR
PRODUCT. WE DO NOT ACCEPT RETURNS FOR INCORRECT CARE OF PRODUCTS.
THE SURFACE OF THIS ITEM IS NOT HEAT RESISTANT.
ALWAYS USE A MAT UNDER HOT OR COLD ITEM TO PREVENT MARKING.
PLEASE KEEP THE ORIGINAL PACKING UNTIL YOUR ITEM IS FULLY ASSEMBLED AND IN PLACE, IN
THE UNLIKELY EVEN YOU NEED TO RETURN THE PRODUCT, IT MUST BE RETURNED BACK IN ITS
ORIGINAL PACKING TO AVOID DAMAGE.
FAILURE TO COMPLY TO THESE PROCEDURES, NO RETURN'S WILL BE ACCEPTED.

Page 2 of 3
USE OF POWER TOOLS TO ASSEMBLE THIS PRODUCT WILL INVALIDATE ANY CLAIM AND
MAY DAMAGE THIS PRODUCT MAKING IT UNSAFE.
PLEASE CHECK THAT YOU HAVE ALL THE PARTS LISTED.
BEFORE YOU START ASSEMBLING IF YOU FIND THAT SOMETHING IS MISSING DO
NOT CONTINUE ASSEMBLY.
PLEASE CONTACT YOUR SUPPLIER IMMEDIATELY.
PLASTIC BRACKET
45X20MM
PLASTIC CABLE TIE
245X7MM
A
B
1
1
HARDWARE LIST

Page 3 of 3
ASSEMBLY IS COMPLETE NOTE:
WALL PLUG & SCREW ARE
NOT SUPPLIED WITH THIS
PRODUCT AS DIFFERENT WALL
MATERIALS REQUIRE DIFFERENT
TYPES OF FIXING HARDWARE &
YOU MUST USE SUITABLE FIXING
HARDWARE FOR TYPE OF WALL
YOU INTEND TO MOUNT THIS
PRODUCT TO WALL.
USE OF POWER TOOLS TO ASSEMBLE THIS PRODUCT WILL INVALIDATE ANY CLAIM AND
MAY DAMAGE THIS PRODUCT MAKING IT UNSAFE.
You will nd one plastic brackets(A) pre xed to the back of the unit. Then attach one plastic
brackets(A)
screwd into the wall as the image shows, use the plastic cable tie(B) connect the two plastic
brackets(A).