LRS TR-7400 Specification sheet

TR-7400 Desc iption
The TR-7400 is designed to booster a transmitter’s signal and “retransmit” the same signal.
The unit comes with the ollowing items:
• The main unit
• 1 right ang e antenna
• 12-Vo t power supp y
Connecting the Antenna
The 3” right angle antenna should be placed on the silver barrel on the side o the main unit,
twisted and locked into place (see picture)
Long Range Systems 1TR-7400 Quick Guide
TR-7400 Transmitter- Receiver
Paging Transmitter Repeater System
QUICK SETUP & OPERATION
Transmit
Power
9VAC
800.437.4996
www.pager.net
CONDOR
CLASS2TRANSFORMER
[phone]
INPUT:AC12OV60Hz19w
OUTPUT: AC9V1800mA
P/N:A91A8
RoHS
UU
LL
LISTED
C
MODEL:48A-9-1800
EIA 3630635S
MADEINCHINA
AC Power Outlet
10V Power
Adapter
Antenna
Main Unit

Positioning and Installing the Booste
Note: The best place to mount your Booster is on a ceiling or wall that is very high. The
idea is to get the signal as high as possible so it “umbrellas” the guest and thus all
pagers can receive it.
The booster operates at its best when installed at the “ ringe” o your area. This means you
should get it as ar rom the transmitter as possible but still be able to receive the transmitter’s
signal.
1. Locate a 110V out et near the se ected insta ation ocation.
2. P ug the power adapter into the out et and into the power connector ho e on the
side of the unit.
3. Ensure that when power is p ugged in, the Red RECEIVE ight wi b ink continu-
ous y to indicate power is on and the unit is operating.
4. P ace the paging transmitter in “Range Test Mode” (see transmitter’s operating in-
structions).
5. Ensure the Red TRANSMIT ight periodica y a ternate f ashes on about every 5
seconds.
• If the periodic TRANSMIT f ash does not occur, move the booster unit c oser to
the transmitter and try again.
• Keep moving the booster toward the transmitter unti the TRANSMIT f ash oc-
curs.
• After estab ishing the correct distance, mount the booster as high as possib e
Normal Range
Transmitter
TR-7400
E tended Range
SETUP
MGR1
MGR2
STAFF
CLEAR
ENTER
1
2
3
4
5
6
7
8
9
0
ABC
DEF
GHI
JKL
MNO
PQR
STU
VW
XYZ
[
T7400A
LongRangeSystems
800.437.4996
F1
F2
F3
F4
Transmit
Power
9VAC
800.437.4996
www.pager.net
:
:
Long Range Systems 2TR-7400 Quick Guide

System Specification
Requi ed voltage: One 110V out et for the pager keypad.
Ope ating F equency: 467.75 MHz
Radiated Powe <120mW
Ope ating Range: Dependent upon pagers used and topography and environment.
Long Range Systems, LLC reserves the right to make changes without urther notice to any products herein.
Long Range Systems, LLC makes no warranty, representation or guarantee regarding the suitability o its prod-
ucts or any particular purpose, nor does Long Range Systems, LLC assume any liability arising out o the appli-
cation or use o any product or circuit, and speci ically disclaims any and all liability, including without limitation
consequential or incidental damages. “Typical” parameters that may be provided in Long Range Systems, LLC
data sheets and/or speci ications can and do vary in di erent applications and actual per ormance may vary
over time. All operating parameters, including “Typicals”, must be validated or each customer application by
customer’s technical experts. Long Range Systems, LLC products are not designed, intended, or authorized or
use as components in systems intended to support or sustain li e, or or any other application in which the ailure
o the Long Range Systems, LLC product could create a situation where personal injury or death may occur.
Should Buyer purchase or use Long Range Systems, LLC products or any such unintended or unauthorized ap-
plication, Buyer shall indemni y and hold Long Range Systems, LLC and its o icers, employees, subsidiaries, a -
iliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney
ees arising out o , directly or indirectly, any claim o personal injury or death associated with such unintended or
unauthorized use, even i such claim alleges that Long Range Systems, LLC was negligent regarding the design
or manu acture o the part, device or system.
1. This device complies with Part 15 o the FCC Rules. Operation is subject to the ollowing two conditions:
(1) This device may not cause harm ul inter erence.
(2) This device must accept any inter erence received, including inter erence that may cause undesired opera-
tion.
2. Changes or modi ications not expressly approved by the party responsible or compliance could void the
user's authority to operate the equipment.
RF wa ning statement:
The device has been evaluated to meet general RF exposure requirement o a mobile device. It is
designed to operate and should be placed in an area with a minimum separation distance to nearby persons o
at least 20 Centimeters.
Long Range Systems, LLC
4550 Excel Park ay, Suite 200, Addison, TX 75001
.pager.net •214.553.5308
Long Range Systems 3TR-7400 Quick Guide
XU-0055 061014