LS SYNCHRO 2 Premium Set User manual

1
SYNCHRO 2 Premium Set
S Status LED
1 All motors up
2 All motors down
3“Back” motor up
4 “Back” motor down
5“Legs” motor up
6 “Legs” motor down
7 Flashlight

2
Learn button
Emergency
descent

3
If the Status LED and the backlight of the remote control are flashing, the remote control has not
yet been synched to the receiver.
Briefly press the learn button on the receiver.
Now, press the “back motor up” button until the motor adjusts. This completes the learning
process.
If the motor does not adjust within 15 seconds, briefly press the learn button on the receiver
again, and press and hold the “back motor up” button until the motor adjusts.

4
If the receiver has not successfully synched to the remote control, you will need to reset them.
Press and hold the learn button on the receiver until the motor adjusts briefly (this happens after
about 10 seconds).
On the remote control, press and hold the 3 buttons on the left (1, 3, 5) simultaneously until the
Status LED lights up continuously (this takes about 5 seconds).
Release the buttons, and the Status LED and the buttons will start flashing again.
The receiver and remote control have been reset to factory settings.
RESET

5
If both bases are to be operated with 1 remote control, then the other remote control can no longer
be used.
Remove the batteries from 1 of the remote controls and set this control aside.
We are now going to connect the working remote control to the other box.
Go to the box that isn’t synched to the remote control.
Now, briefly press the learn button on the receiver of this box.
Next, press and hold both top buttons on the remote control until the motor of this box adjusts
briefly.
The bases are now working synchronously.
Synchronising 2 boxes