Lighting Services Inc BP75 Series 12V MR16
©2000 Lighting Services Inc Sales & Manufacturing / 2 Holt Drive, Stony Point NY 10980-1996 / (845) 942-2800 Fax (845) 942-2177 IS-0106~
Lamp Installation/Relamping(Cont’d)
1) Press relamping button to release lamp housing and pull lamp housing back and down.
2) Lift up and pull back to disengage the lamp-housing hinge. Pull lamp housing straight back to remove.
3) Pull and hold back the Lamp Retaining Clip and pull the lamp straight out to remove.
4) Hold Back the Lamp Retaining Clip and Align the Lamp Base with the Lamp Locator Bracket and carefully press
lamp into socket until lamp seats on lamp centering bracket. (NOTE: Due to pin alignment in lamp, it is
sometimes necessary to rotate lamp 180
°
to insert easily into socket.)
5) Reverse steps 1 and 2 to reinstall lamp housing.
Lens Assembly Installation
Align lens assembly mounting tabs and insert into lens assembly mounting slots. Rotate clockwise until lens
assembly locking tab “clicks” into place. To remove, press and hold lens assembly locking tab and rotate lens
counter-clockwise.
Accessory Cartridge Installation
Projection patterns for the BP75 Series are manufactured by others and are theatrical industry standard “D” size (not
LSI “D” size). The BP75 has been designed to accept a double combination of any metal or glass patterns or dichroic
color filters sized from 1.937” (48mm) to 2.100” (53mm) overall diameter, with a maximum image diameter of 1.574”
(40mm) and a maximum edge thickness of 0.125” (3.18mm).
1) Remove one gobo holder by simply rotating in a counter-clockwise direction.
2) Holding accessory cartridge in a horizontal position, place color filter or glass or metal gobo into center of the
accessory cartridge, ensuring it is positioned as close to center as possible. The gobo must be placed in the
accessory cartridge upside down and backwards for the projection to be in the proper orientation.
3) Reinstall the gobo holder by simply rotating in a clockwise direction. If you experience any difficulty threading the
gobo holder into the accessory cartridge, rotate it in a counter-clockwise direction until it seats properly.
4) Repeat steps, if required, to install a second accessory.
5) Adjust image rotation handle to properly orient image.
LENS ASSEMBLY
MOUNTING SLOTS
LENS ASSEMBLY
LOCKING TAB
LENS ASSEMBLY
MOUNTING TABS CLOCKWISE TO
INSTALL
COUNTER-CLOCKWISE TO
REMOVE
FILTER OR GOBO
GOBO HOLDER
0.125 MAX.
0.010 MIN.
1.574
1.937
2.100
LAMP LOCATOR
BRACKET LENS ASSEMBLY
LOCKING TAB
LAMP RETAINING
CLIP
LAMP LOCATOR
BRACKET
SOCKET
PULL AND HOLD BACK
THE LAMP RETAINING CLIP
LAMP
LOCATOR
BRACKET
