Wireless kinetic energy switch and wireless receiving controller can
be paired with any combination. A controller can have a maximum
of 10 switch keys. A switch key can pair to an unlimited number of
controllers within the control distance.
LUC303 dual receiver has two outputs. Each output can be
independantly matched. The receiver has 1 red and 1 blue LED,
corresponding to channel 1 and channel 2 respectively. Click the
button twice to change channel. The LED of the corresponding
colour will flash twice to indicate the channel. You can push the
button to determine the current channel.
Specific steps are as follows:
Switch Pairing
1. Press and hold the button on the controller for 3 seconds.
2. When you see a slow flash (1 flash in 1 second) remove
your finger. Now the controller is in pairing mode. This mode
will last 10 seconds.
3. During this ten seconds, press down the switch key one or
more times until the flash is gone and the controller’s indication
light is completely off. Pairing is now complete.
*Note: Before pairing, clear controller memory by following actions listed
under Clear Memory (reset).
