CNCJ-72FW CNCJ-80K – RULES FOR
SAFE OPERATION
!The engine section of this rammer requires an adequate free flow of cooling air.
NEVER operate the rammer in any enclosed or narrow area where free flow of the air
is restricted it will cause serious damage to the rammer or engine and may cause
injury to people. Remember the rammer’s engine gives off DEADLY carbon
monoxide gas.
!ALWAYS refuel in a well-ventilated area, away from sparks and open flames.
!ALWAYS use extreme caution when working with flammable liquids. When refueling,
stop the engine and allow it cool. DO NOT smoke around or near the machine. Fire
or explosion could result from fuel vapors, or if fuel is spilled on a hot engine.
!NEVER operate the rammer in an explosive atmosphere or near combustible
materials. An explosion or fire could result causing severe bodily harm or even
death.
!DO NOT smoke around or near the machine. Fire or explosion could result from fuel
vapors, or if fuel is spilled on a hot engine.
!Topping-off to filter port is dangerous, as it tends to spill fuel.
!Stop the engine when leaving the rammer unattended.
!Maintain this equipment in a safe operating condition at all times.
!ALWAYS stop the engine before servicing, adding fuel and oil.
!NEVER run engine without air filter. Severe engine may occur.
!ALWAYS service air cleaner frequently to prevent carburetor malfunctions.
!ALWAYS check the machine for loosened threads or bolts before starting.
!ALWAYS be sure the operator is familiar with proper safety precautions and
operations techniques before using rammer.
!ALWAYS store equipment properly when it is not being used. Equipment should be
stored in a clean, dry location out of the reach of children.
!DO NOT operate this equipment unless all guards and safety devices are attached
and in place.
!CAUTION must be exercised while servicing this equipment.
!Keep all inexperienced and unauthorized people away from the equipment at all
times.
!Unauthorized equipment modifications will void all warranties.
!NEVER pour or spray water over the engine.
!Test the engine ON/OFF switch before operating. The purpose of this switch is to
shut down the engine of the rammer.
!Refer to the ROBIN Engine Owner’s Manuel for engine technical questions or
information recommended by Multiquip for this equipment.
