Lumens OIP-D50E User manual

www.MyLumens.com
Power Indicator
Link Indicator
RS-232 Port
ISP SEL On/Off
IR Input/Output
IR Receive Window
Loopback and Link Button
1. Product Introduction
1.1 OIP-D50E Encoder Overview
2. Installation and Connections
ISP Button
Reset Button
Mode and Anti-dither Button
VGA Loopback Output Port
11
Front panel
Rear panel
11
※
Use an HDMI cable to connect the video source device to the HDMI
input port on the D50E encoder.
Use an HDMI cable to connect the video display device to the HDMI
output port on the D50D decoder.
Use a network cable to connect the OIPnetwork port of the D50E
encoder, D50D decoder, and D50C controller to the network switch
of the same domain, so that all OIPdevices are in the same local
area network.
Plug the power adapter into the power ports of D50E encoder, D50D
decoder, and D50C controller and connect to the power source.
(If the network switch supports PoE (IEEE802.3af) for power supply,
power can be obtained directly through the network switch.)
Steps - can complete the signal extension. You can use the
WebGUI operation interface to control the video display device
connected to the D50C controller. You can also connect a computer
and an IR emitter/receiver. Please follow the steps below:
Connect the IR emitter/receiver to the D50E encoder and D50D
decoder to receive infrared signals from the remote control, and use
the remote control to control the controlled device.
VGAdisplay connect to D50D decoder to output analog image and
audio.
Connect the computer to the D50E encoder, and the controlled
device to the RS-232 port of the D50D decoder. The computer can
issue RS-232 commands to the controlled device, and the controlled
device will execute those commands.
4. Suggestions for the Switch Setting
1.2 OIP-D50D Decoder Overview
Front panel
Rear panel
11 12
Power Port
USB Port
OIP Network Port
HDMI Input
LINE Input
LINE Output
12 RS-232 Port
MIC Input
LINE Output
Optical Output
HDMI Output
VGA Output
ISP Button
OIP Network Port
Power Port
Power indicator
Link Indicator
USB 2.0 Port
USB 1.1 Port
Reset Button
Switch and Mode Button
Channel and Link Button
IR Receive Window
IR Input/Output
Channel and USB Button
ISP SEL On/Off
11
OIP-D50E
OIP-D50D
Network Switch
(Supported for PoE)
IR Output
IR Input
Video/Audio
Amplifier
Digital Stereo
Output
Monitor
MIC Input
USB Peripheral Devices
RS-232
Connection
IR Output
IR Input
Video Display Device
Smart TV
HDMI
Output
LAN
Controlled Device
OIP-D50E/D50D
Copyright © Lumens Digital Optics Inc. All rights reserved.
3. Control Methods
1. The WebGUI interface will be displayed on the video display device connected to the D50C controller. You can connect a keyboard and mouse to the
D50C controller to perform control and setting on the WebGUI interface.
2. Open the web browser and enter the IP address corresponding to the CTRLnetwork port of the D50C controller to control it on the web page.
VoIPtransmission will consume a lot of bandwidth (especially at higher resolutions), and it needs to be paired with a Gigabit network switch that supports
Jumbo Frame and IGMP(Internet Group Management Protocol) Snooping. It is strongly recommended to be equipped with a switch which includes
VLAN(Virtual LocalArea Network) professional network management.
1. Please set Port Frame Size (Jumbo Frame) to 8000.
2. Please set IGMPSnooping and relevant settings (Port, VLAN, Fast Leave, Querier) to “Enable”.
VGA Loopback
Output
RS-232
Connection
Speaker
Computer
Monitor
USB
Connection
Analog Stereo
Input
Analog Stereo
Output
HDMI
Input Media Player
LAN
VGA
Input OIP D50C-
Quick Start Guide
To download the updated software, multilingual manuals, and Quick Start Guide, please visit Lumens
website at:
®
.https://www. /supportMyLumens.com
.:ytnarrawruoyetavitcaesaelP www.MyLumens.com/reg
Important
5100482-50 NOV. 2022
Speaker
Analog Stereo
Output

RS-232
ISP
1.
1.1 OIP-D50E
2.
ISP
VGA
11
11
4. Switch
1.2 OIP-D50D
11 12
VGA
RS-232
USB
OIP
HDMI
LINE
LINE
12 RS-232
LINE
HDMI
VGA
ISP
OIP
USB 2.0
USB 1.1 USB
ISP
11
OIP-D50E
OIP-D50D
USB
HDMI
( PoE)
LAN
VGA
USB
RS-232
HDMI
OIP D50C-
OIP-D50E/D50D
Copyright © Lumens Digital Optics Inc. All rights reserved.
www.Lumens.cn
Lumens
®
。
/
/
IMDHE05DIMDH
IMDHD05DIMDH
D50ED50DD50C
OIP
OIP D50ED50DD50C
(PoE (IEEE 802.3af)
)C05D- WebGUI
D05DE05D
RS-232RS-232
D50ED50D
VGAD50D
3.
IUGbeWC05DIUGbeWC05D.1
PILRTCC05D.2
VoIP ( ) Jumbo Frame( ) IGMPSnooping(
)(NALVtibagiG)
1. Port Frame Size(Jumbo Frame)8000
2. IGMPSnooping(Port, VLAN, Fast Leave, Querier) ” ”
https://www.Lumens.cn/support