luminii Optic Arts LineLED User manual

Page 1 of 2
REV0.0 12052019
LineLED 24V - Installation Instructions
Please read all instructions prior to installation and keep for future reference!
1. Product should be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
3. Use only with Class 2 power unit. Utiliser seulement avec Classe 2 unite d’alimentation electrique.
4. For under-cabinet or shelf mount.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
Clean the area thoroughly where the LineLED will
be installed.
Remove the paper backing from the LineLED and
firmly press down making sure
there are no air bubbles that can cause surface
irregularities. Do not remove the
adhesive, removing the adhesive may cause
arcing of the Line LED tape.
1
NOTE - Avoid bending the
LineLED in flat bends which
may damage the LEDs
LineLED
adhesive paper
backing
Attention: Always test LineLED operation before installing.
Connect LineLED to power supply to ensure it is working
properly and no damage has occured during shipping.
NOTE - When removing backing
& laying LineLED to surface avoid
ripples on LineLED.
ripple
2
If length of LineLED needs to be adjusted on site, simply
cut the LED strip in between solder pads. Always cut
from end with no connector/wire leads.
solder
pads

Page 2 of 2
REV0.0 12052019
LineLED 24V - Installation Instructions
Please read all instructions prior to installation and keep for future reference!
1. Product should be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
3. Use only with Class 2 power unit. Utiliser seulement avec Classe 2 unite d’alimentation electrique.
4. For under-cabinet or shelf mount.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
RECOMMENDED LAYOUT FOR MULTIPLE ADJACENT RUNS OF LINELED FED WITH SEPARATE POWER SUPPLIES
+
+
24VDC
class II
power
supply
PURPLE
PURPLE
power feed wires
from LineLED
Connect positive wire (plus
sign tag or red wire) to
RED low voltage wire from
power supply. Also, connect
negative wire (no tag or
black wire) to PURPLE low
voltage wire from power
supply.
120VAC line
voltage wires 24VDC low voltage wires
+
_
RED
3-pin connector and 72” wire lead power feed wiring field-cut connector power feed wiring
power feed wires
from LineLED
Connect positive middle
wire (plus sign tag) to
RED low voltage wire
from power supply. Also,
connect BOTH negative
wires (no tags) to PURPLE
low voltage wire from
power supply.
24VDC low voltage wires
+
_
RED
3
LineLED
4Always ensure power to power supply is off! Follow diagrams to connect power feed wires to power supply. Refer to power supply
instructions for wiring line voltage side.
Position power supplies either in the middle of two runs or at the opposite ends.
power supply
LineLED
power supply
power supplies placed in
the middle of two adjacent
runs
power supplies placed at
the opposite ends of two
adjacent runs
OR
24VDC
class II
power
supply
120VAC line
voltage wires