Luminiser 70090048300005 User manual

Lantern Instruction Manual
FOR OUTDOOR AND INDOOR USE.
Identity number
70090048300005-IM01
Date of issue
01.11.2018
Pages
Side 1/ 2
CALIFORNIA PROPOSITION 65 WARNING: Burning candles and fuels result in the emission of carbon monoxide, soot and other combustion by-products which are known
by the state of California to cause cancer, birth defects, or reproductive harm.
Identification of the product
Brand name
Luminiser
Trade mark
Luminiser
Product
70090048300005
Description
Luminiser Lantern
Email
[email protected]om
Website
www.luminiser.com
Address
Luminiser, 8517 Narvik, Norway
Dimensions
12 CM X 12 X 18 CM
Weight
400 G
Light
100-150 LUMENS
Led
Parameters
Max Rating
Power
500 mW
Forward current
188 mA
Reverse Voltage
7 V
(tp≤10ms, Duty cycle=1/10)
450 mA
Standards
MD 2006/42/EG (AFS 2008:3)
2004/108/EC
2009/125/EC
2009/128/EC
1194/2012/EU
34A/1554/CD
EN55015:2006, A1:2007, A2:2009
EN 61547:2009
2002/35/EC, 2015/863/EU
1907/2006/EC
IEC 82079-1
Cert. ref.
SGS Ref NO. GZ060304640EC
BEFORE FIRST USE:
READ, UNDERSTAND, AND FOLLOW ALL INSTRUCTIONS AND WARNINGS BEFORE OPERATING THE
LUMINISER. FAILURE TO COMPLY WITH THE PRECAUTIONS AND INSTRUCTIONS PROVIDED CAN RESULT IN
PROPERTY LOSS OR DAMAGE, SERIOUS BODILY INJURY, OR DEATH.

Lantern Instruction Manual
FOR OUTDOOR AND INDOOR USE.
Identity number
70090048300005-IM01
Date of issue
01.11.2018
Pages
Side 2/ 2
CALIFORNIA PROPOSITION 65 WARNING: Burning candles and fuels result in the emission of carbon monoxide, soot and other combustion by-products which are known
by the state of California to cause cancer, birth defects, or reproductive harm.
Modification of product
Any modification of the product by the user is
not recommended and any consequences will
not be covered by Luminiser support services
or Luminiser product warranties.
Safety information
The Luminiser Lantern is designed to hang
from the handle or be placed on a flat and
stable surface. The air outlet on the top must
always be open for the heat to escape and
must be at least 25cm below any surface
above.
Operating Instructions using a Tea Light or
Lamp Oil Unit
1. Unscrew the red Candleholder from the
base of the Luminiser.
2. Light the Tea Light and place it in the
Candleholder in an upright position or light
the Lamp Oil Unit.
3. Screw the Candleholder or Lamp Oil Unit
into the base until you hear a click, which
locks it in the right position.
4. Depending on the outside temperature,
after 30-60 seconds, the Luminiser Lantern
is ready to light up your world.
5. Select your preferred lighting option.
0 = Tea Light only
1 = front LED
2 = both side LEDs.
6. To shut down the Luminiser, simply blow
out the flame through the air outlet in the
top, or unscrew the red Candleholder or
Lamp Oil Unit from the base and blow out
the flame.
Maintenance of product:
A small layer of soot may build up in the
chimney after regular use. The soot can be
easily removed with a pipe cleaner.
Luminiser Tea Lights & Lamp Oil Units
Luminiser Tea Lights are recommended to be
used at all times. Each is specially designed to
provide the correct flame height and energy to
produce best results. Other Tea Lights may be
used, but the quality and size of the flame may
affect the strength of the LED.
Luminiser Lamp Oil Units are uniquely designed
for the Luminiser Lantern.
Warning!
General safety sign. Pay close attention to
the following information regarding the
correct and safe usage of the products.
Be sure to burn Tea Lights out of
reach of children and pets.
Never leave a burning Tea Light
unattended. Always extinguish the Tea
Light before leaving a room
Avoid direct inhalation of any
smoke.
Never use liquid to extinguish.
Using liquid to extinguish the flame may
cause hot wax to splatter and glass
container to fracture.
Do not burn Tea Lights on or near
anything that may catch fire.
Always remember that the Tea Light is a
naked flame. Pay close attention to the
flame to avoid a fire hazard.