Luowice R8 User manual

Camera Installation Instructions
1. Screw the antenna
Please refer to the below image and adjust the Antenna till it is at an angle of
90 degrees to the camera. Please avoid the Antenna and the camera to be in a
straight line.
Note：Please screw the antenna on till it is in 90 degree to the camera.
Please avoid screwing the antenna too harsh after it is screwed firmly to the
camera. Otherwise the screw interface will be damaged.

2. Assemble the Camera and the Bracket
Please avoid adjusting the angles of the camera bracket directly by hand. The
angles of camera shall be adjusted via the PTZ function on the mobile APP or PC
Client. Adjusting the bracket manually might cause damage to the PTZ function.
Please put the wires (5, 6, 7) through the bracket (4) one by one. Put all the
three wires through the bracket at the same time can make them be stuffed in
the middle and fail to get through. Please place the screw (3) to the right
interface (2, 1) to assemble the camera.

3. Configure your camera to router
Please refer to the user guide or visit the video instruction, and configure your
camera to router on a wired/wireless connection via phone app (CamHipro).
Access this page to the YouTube Video instruction.
www.youtube.com/watch?v=YncokKOK9hE&feature=youtu.be
Or scan the QR code below to view the YouTube Video instruction.

4.Choose a location and Mount your camera to the wall.
Please refer to the below instructions to mount your camera.
①Place the mount in its desired location.
②Using a sharpie, make marks on the wall where each screw should go.
③Drill a hole for each screw using an electric drill
④Hammer in any molding pins.
⑤Screw the mount into the wall.
⑥Position the camera to your desired angle.
Sources and Citations
https://www.wikihow.com/Install-a-Security-Camera-System-for-a-House