Luraco Dura-JET 4 User manual

Dura-JET 4
MODEL L0704B
CLEAN- RELIABLE- WORRY FREE
When using electrical equipment, basic safety precautions should always be followed to reduce the risk of
fire, electric shock, and injury to persons, including the following:
1. Read and follow all instructions before using the equipment
2. Keep the cord out of heavy traffic area. To avoid fire hazard NEVER put the cord under rugs, near heat
generating devices
3. Always turn off the equipment before servicing
4. Do not drop or insert any object into any openings
5. Do not operate any equipment with a damaged parts
6. Any other use not recommended by the manufacturer may electrical shock or injury to persons
7. Never use outdoors
8. Do not attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void the
warranty.
After reading this owner’s guide, if you have any questions or comments, please call [phone] or contact our technical
support department at [email protected] or visit our website at www.luraco.com for more information
USER’S MANUAL
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS

FEATURES - OPERATIONS
Dura-JET 4 Features
•Sanitizable - Easy Cleaning - Bacteria Free
•Military heavy duty water sealing technology- extremely reliable
•Dual powerful massage Jet-streams with air control
•Easy to install, clean and service
•Air output
•Built-in color LED (optional)
Dura-JET 4 Installation
1. Determine the surface of the tub that you want to install the unit, ensure that the surface is flat
2. Locate a position to drill a hole with the dimensions as shown in Fig. 1
3. Insert the unit into the hole from inside the tub
4. Connect the air hose connector to an air control button
5. Use a hand screwdriver to tighten the four screws
6. Plug the power cord of the unit into the spa power box
3.5 in/90mm3.5 in/90mm
Figure 1. Drill Instruction Figure 2. Motor Dimension
Attention: Any modification to the Dura-JET 4 will void the warranty
Cleaning Instructions
1. Ensure the unit is off
2. Remove the front cover
3. Remove the impeller and the impeller cover
4. Use anti bacterial solution to clean all the plastic parts
5. Reassemble the system