INSTRUCTION MANUAL
Baby bed rail safety guard
Made in China
IMPORTANT!
Please keep this manual for future use.
Do not use when any part is missing. Make sure it’s installed right by
adult.
Spare parts:
A. 2 flat steel tubes, one with
plastic connection;
B. 2 steel tubes with the
plastic connection on both
side;
C. 2 elbow steel tube;
D. 2 straight steel tubes;
E. fabric cover.
carry bag
How to install the bed rails
1. Find the part A, connect the 2 flat pipes by the plastic on the tube. See Fig1
2. Connect part C by the clips on the tube. See Fig 2
3.Connect D by the clips on the tube.See Fig 3
4. Find the fabric cover, using the connected C across the top of the mattress. Be
careful, not to broke the fabric cover. See Fig 4
5. Connected C with tube B using the clips on tube. Make sure it’s the right direction.
See Fig 5
6. Connected other B tube with the other side of C, also in right direction.
7. You will get the product shown as Fig 7.
8. Find the connected flat tube A, assembling A with the B plastic part in both sides. See Fig 8a
and 8b.
9. Using connected D across the fabric cover’s another tube cover, and clip it to the plastic on
both sides. See Fig 9.
10. make sure D locked well to the plastic. See Fig 10
11. Pull the bed rails to make it in a 90 degree angle, and make sure it’s well locked. See Fig 11
Right side is the finished
product.
The arrow shows the folding
direction. Folding by pull up the
lock on both sides.
