LUX Royal 550S User manual

OWNER MANUAL

SAFETY & PRECAUTION
Please read the instructions carefully before installing the spa.Carefully follow the instrutions,your spa will give
you years of beauty and service.
If a crack occurs in the glass bowl, DO NOT manually handle the bowl unless the proper attire is worn.
Under no circumstances must the bowl be used by your customers as you can be held accountable for
any injury that may occur. We are not liable for any injury that may occur.

SAFETY & PRECAUTION

Control Panel
IDENTIFY YOUR FOOT-SPA
1
2
3
4
5
6
7
8
9
10
9
13
1. Glass/Acrylic Bowl
2. Contemporary Base with height adjust-able
3. Armrest
4. Folding Manicure Tray
5. Backrest & Massage
6. Seat Cushion
7. Adjustable Footrest
8. Deluxe Hand – spray
9. Drain Knob
10. Jet
11. Exhaust Fan
12. Jet Switch
13. Drain Pump (optional)
14. Faucet
15. Air vent
11
12
14
13
12
15
15

IDENTIFY YOUR FOOT-SPA
SEAT OPERATION
SPA DIMENSION
Armest can be raised up/down
Maincure tray can be folded up/down
50’’
27’’
70’’
LUX
31.5’’ 5’’
15’’

TYPICAL FOOT-SPAS
Clearance
Center
60’’
60’’
Foot-spa #1 Foot-spa #2
Center
WALL CLEARANCE
FOOT-SPA CLEARANCE
20” - 24”

Center
Foot-spa #2
110v, 60Hz, 15 Amp, GFCI protected grounded circuit must be use to supply power each individual pedicure spa, and
the main circuit breaker must be at 25Amp. For maximum of two units per each electrical
outlet
Spa Chair Rate : 120VAC, 60HZ, 10A
1
INSTALLATIONS
3/8 '' Hot & Cold Fitting

VENTILATION
Ventilation
Exhaust Fan
●Exhaust Fan 130 cfm
●DC 12V
●Amp 2.5A
1”
Discharge
Pump Exhaust fan
actuation air
switch
24”
24”
50''

1. To fill water:
The foot-spa is provided with a single hot and cold mixing valve located on the front of your spa as shown.This is a pressure
bal-ance valve that requires you to lift the handle to start the water flow and to adjust to thetemperature that is desired. The
clean jet motor must be completely submerged in water.
CAUTION: DO NOT USE FOAMING, SUDSING OR MINERAL OIL BASED ADDITIVES IN THE WATER.
2. To Auto Fill (Optional)
With drain open. Turn on water with mixer valve handle
Press auto fill air switch (brown & chrome)
Adjust mixer for desired water temperature
Close drain valve, bowl will fill to set water level and shut off
Mixer valve is now set open and at temperature setting for the rest of the day
*Mixer valve must be turned off at the end of the day
3. To start whirlpool:
Press the jet button as shown. This will start your Jet motor. You may stop the whirlpool function at any time by pressing the
button again.
4. The foot-spa is equipped with a hand held sprayer. To activate the hand shower, pull the hand shower from the receptacle
and depress the thumb control on the sprayer handle. This will turn on the water. When you release pressure on the thumb
control this will turn the water off.
5. To drain whirlpool tub:
Open the drain plug by turning the control knob as shown
OPERATIONS & USE
Jet Switch
Faucet
Hand Spray
Drain Knob
Exhaust Fan
Control Panel
BASIC PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE FOLLOWING:
1. Read and follow all instructions
2. DANGER. To reduce the risk of injury, do not permit children to use this unit unless they are supervised at all times
3. Use this unit only for its intended use as described in this manual. Do not use attachments that are not Recommended by the
manufacturer.
4. Never drop or insert any object into any opening.
5. Do not block jets during whirlpool operation.
6. The unit must be connected to an electrical supply circuit that is protected by a ground fault circuit interrupter.
7. The clean jet motor is magnetically driven and is insulated twice. Therefore it does not require to be bonded.
Save these instructions
Discharge Pump (Optional)

We
CLEANING & MAINTENANCE
We

Turn the Top Plate clockwise until you hear a “click-sound”
6.Remount the Magnet Jet onto the pedicure bowl by aligning the pegs so that the tab is at
the top of the Magnet Jet.
-Do not run magnet jets without water. This will void your warranty
-Do not place two wet ends in the same bowl when cleaning the jet’s strong
magnets could cause injury (pins your fingers)
-Do not attach two wet ends to each other. Doing so will cause breakage to
wet ends and will void the warranty
CLEANING & MAINTENANCE

Lux Spa
Lux spa
Lux Spa
Lux Spa
1. Limited One (1) Year warranty on the Whirlpool Pump.
2. Limited One (1) Year warranty on the Clean Jet (Dry End)
3. Limited Three (3) YearsPart-Only warranty which covers the Hydraulic System, upper massage mechanism system
4. Lux Spa will pay standard shipping charges on all replacement part during the first 90 days of the stated Warranty Period.
After 90 days the consumer is responsible for all labor and shipping costs occurred.
Lux Spa
4. All parts are to be shipped by UPS Ground or USPS Service.