elements are fixed. Repeat the described procedure for all lockable elements and side foldable
wings.
Step 2: Assembly of the feet
Please take the 2 feet elements and put the bar A into the whole which
you can find in the middle of both feet elements. Press the bars
carefully into the wholes and make sure that they are well fixed. What
you now see in front of you is the basis of the luxury dryer.
Step 3: nstallation of the
bars B and C
Next, please put the bars B
into the whole that you can
find on top of the feet
element (in the middle).
Make sure that the bars are
well fixed in order to
guarantee the stability of the clothes dryer. Please take care: These two bars have to be installed in
the right direction (the omission must show towards the top of the dryer, see picture concerning step
3). Then please put the bars C onto the already fixed bars B and make sure that the bars are well
connected and fixed.
Step 4: nstallation of the wings
Please put now the side foldable wings onto the bars C on
each side. In order to do so, you just have to put the
whole of the lockable element through the bar, and then
you can press the element downwards into a desired
position. In that way, you can position all the wings in a
different height so that you have enough place afterwards
to put a lot of clothes. The red button on the lockable
element has to be ‚opened‘ while moving the wing.
Otherwise the wing will be fixed. Please do not push the
elements if the lockable elements are fixed. According to the one click principle, you should always
have a look at this red button.
Step 5: Connection pieces for bar D
Please put the 2 included connection
pieces into the ends of bar D and make
sure that they are well fixed. Then you
can put the bar D onto the bars C.
Step 6: nstallation of the 2 side wings
Please attach the side wings as shown in
the picture according to the one click