LYNDON FURNITURE BRATTLEBORO User manual

BRATTLEBORO BED ASSEMBLY
Base Part Location and Verification
Location
Quantity
Description
QC Check
Bed Box
1
Headboard Assembly
Bed Box
1
7 1/4” Base Footboard
Bed Box
1
5” Footboard
Bed Box
1
Support
Bed Box
2
7 1/4” Base Rail
Rail Box
2
5” Top Rail
Hardware List and Verification
Quantity
Description
QC Check
2
Bed Hardware
16
Wood Dowels
12
1 5/8”Screws
Center Support for King / California-King only
QUALITY CONTROL CHECK PERFORMED BY: _____________________________________
ASSEMBLY INSTRUCTIONS:
1) BASE ASSEMBLY: ATTACH THE 7 1/4” BASE RAILS TO BOTTOM BOARD OF
HEADBOARD AND 7 1/4” BASE FOOTBOARD. MAKE SURE THE MACHINED
HOLES FACE INSIDE.
2) FOLLOW THE STEPS BELOW TO ATTACH THE RAILS.
Page 1
7 1/4”
Base Rail
7 1/4”
Footboard Rail
7 1/4”
Base Rail

3) TOP RAIL ASSEMBLY: ATTACH 5” TOP RAILS TO 5” FOOTBOARD. MAKE
SURE THE MACHINED HOLES FACE INSIDE.
4) FOLLOW THE STEPS BELOW TO ATTACH THE RAILS.
5) TOP RAIL ASSEMBLY: ALIGN PILOT HOLES AND ATTACH THE SUPPORT,
SEEN IN FIGURE 1. USE 5 –1 5/8” SCREWS TO ATTACH. CIRCLED HOLE
FOR STEP #7 ONLY.
6) ATTACH THE TOP RAIL ASSEMBLY TO THE TOP BOARD OF HEADBOARD.
7) USING THE CIRCLED HOLE IN FIGURE 1, FINISH SCREWING THE SUPPORT
INTO PLACE WITH 1 –1 5/8” SCREW.
8) SPACE OUT SLATS EVENLY. SECURE THE FIRST, LAST, AND MIDDLE SLATS
USING 6 –1 5/8” SCREWS.
FIGURE 1
FINISHED ASSEMBLY
Page 2
Support
5”Top Rail
5”Footboard
5”Top Rail

CENTER SUPPORT ASSEMBLY
Base Part Location and Verification
Location
Quantity
Description
QC Check
Rail Box
1
Assembled Support
Base Part Location and Verification
Quantity
Description
QC Check
2
1 1/2”Screws
ASSEMBLY INSTRUCTIONS:
1) CENTER THE SUPPORT ASSEMBLY UNDER THE BED SLATS.
2) USE THE 2 –1 1/2” SCREWS TO ATTACH TWO SLATS TO EACH END OF THE
SUPPORT.
Newbury bed shown for Center Support
reference only
Headboard End
Footboard End