M-Elec Valo ML-2819SDIM User manual

The single colour controller offers smooth and consistent remote dimming via RF (Radio
Frequency) to control any LED product connected to the receiver (purchased separately). The ML-
2819SDIM also features 4 zone control and 3 memory functions that can memorise your perfect
settings.
ML-2819SDIM
Product information
Colour control DIMMING
Operation voltage 4.5 VDC
Operation Frequency 434MHz
Dimensions 55x120x17MM
Remarks 
Warranty 
TECHNICAL INFORMATION 
T. 1300 222 445 | www.melec.com.au melec.com.au/legal/warranties
PART No. 
Colour control , DIMMING
Input voltage 12-24VDC
Output current 
Output Power 5x48-96W
Output type 12-24V constant voltage output
Operating temperature °°C
Dimensions 145x46.5x16mm
Warranty 7 years
Receiver (purchased separately)
3

T. 1300 222 445 | www.melec.com.au melec.com.au/legal/warrantiesT. 1300 222 445 | www.melec.com.au melec.com.au/legal/warranties
BUTTON GUIDE
WIRING DIAGRAM (ML-VLC-C5)
WIRING DIAGRAM
OPERATION
1. Learning (matching)








2. DIM Wheel
❶ ❷ ❸ ❹❶ ❸
-

3. Brightness Up and Down button



4. Brightness level button
 ❶ ❷ ❸ ❹

 
 
 
 
5. Save and Recall button
A: Save color temperature
❶ ❷ ❸ ❹


B: Recall
❶ ❷ ❸ ❹

Deleting pairing to RF remotes:


SS11 SS22
SS33
SS11 SS22
SS33
PLEASE NOTE

• Read instructions carefully before attempting to install the fitting. Retain this guide for future reference
• Disconnect power before installing or servicing
• This fitting is for indoor use and should not be used in areas with limited ventilation or high ambient temperatures
• 
• 
• 000)
• Correct electrical polarity must be observed as the wrong polarity may destroy the product and is not covered under warranty
• Damage by corrosion will not be honoured as a material defect claim. It is the user’s responsibility to provide suitable protection against
corrosive agents such as moisture, condensation and other harmful elements
