M-system R3-DA64A User manual

5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: [phone] Fax: [phone] E-mail: [e-mail]
EM-8412 Rev.5 P. 1 / 4
INSTRUCTION MANUAL
DISCRETE INPUT MODULE
(Di 64 points; with external excitation supply) MODEL R3-DA64A
BEFORE USE ....
Thank you for choosing M-System. Before use, please check
contents of the package you received as outlined below.
If you have any problems or questions with the product,
please contact M-System’s Sales Office or representatives.
■PACKAGE INCLUDES:
Discrete input module.........................................................(1)
■MODEL NO.
Confirm Model No. marking on the product to be exactly
what you ordered.
■INSTRUCTION MANUAL
This manual describes necessary points of caution when
you use this product, including installation, connection and
basic maintenance procedures.
POINTS OF CAUTION
■CONFORMITY WITH EU DIRECTIVES
• The equipment must be mounted inside the instrument
panel of a metal enclosure.
• The actual installation environments such as panel con-
figurations, connected devices, connected wires, may af-
fect the protection level of this unit when it is integrated
in a panel system. The user may have to review the CE
requirements in regard to the whole system and employ
additional protective measures to ensure the CE conform-
ity.
■HOT SWAPPABLE MODULES
• Replacing the module does not affect other modules on
the same base. Thus, the module can be replaced while
the power is ON. However, replacing multiple modules
at once may greatly change live voltage levels. We highly
recommend to replace them one by one.
■GENERAL PRECAUTIONS
• DO NOT set the switches on the module while the power
is supplied. The switches are used only for maintenance
without the power.
■ENVIRONMENT
• Indoor use.
• When heavy dust or metal particles are present in the
air, install the unit inside proper housing with sufficient
ventilation.
• Do not install the unit where it is subjected to continuous
vibration. Do not subject the unit to physical impact.
• Environmental temperature must be within -10 to +55°C
(14 to 131°F) with relative humidity within 30 to 90% RH
in order to ensure adequate life span and operation.
■WIRING
• Do not install cables close to noise sources (relay drive
cable, high frequency line, etc.).
• Do not bind these cables together with those in which
noises are present. Do not install them in the same duct.
INSTALLATION
Use the Installation Base (model: R3-BSx).

R3-DA64A
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: [phone] Fax: [phone] E-mail: [e-mail]
EM-8412 Rev.5 P. 2 / 4
COMPONENT IDENTIFICATION
9
10
11
12
13
14
15
16
1
2
3
4
5
6
7
8
SW3
ON
4
3
2
1
A
1
B
1
A
20
B
20
B
A
CN1CN2
2
1
RUN LED
ERR LED
Input Status Indicator LEDs
■ FRONT VIEW ■ SIDE VIEW
Read
Rate
Group Selector*
Input Connector
• Connector Pin
Assignment
*Status Indicator LEDs show input status by 16-point group specified with Group Selector.
Group Selector position 1 means CN1, while 2 means CN2.
Group Selector position A means Side A pins, while B means Side B pins.
■STATUS INDICATOR LED
RUN indicator: Bi-color (red/green) LED;
Red when the bus A operates normally;
Green when the bus B operates normally;
Amber when both buses operate normally.
ERR indicator: Green LED turns on in normal operating
conditions.
Input status indicator:
Red LED; turns on with the input ON.
■GROUP SELECTOR
Switches the input status indicator.
CN1:
A. 1 – 8: Di 11 – Di 18
9 – 16: Di 21 – Di 28
B. 1 – 8: Di 31 – Di 38
9 – 16: Di 41 – Di 48
CN2:
A. 1 – 8: Di 51 – Di 58
9 – 16: Di 61 – Di 68
B. 1 – 8: Di 71 – Di 78
9 – 16: Di 81 – Di 88
■SIDE DIP SW
• Read Rate: SW3-2, 3-3, 3-4
SW READ RATE (≤ msec.)
10 (*)1 5 20 50 70 100 200
SW3-2 OFF ON OFF ON OFF ON OFF ON
SW3-3 OFF OFF ON ON OFF OFF ON ON
SW3-4 OFF OFF OFF OFF ON ON ON ON
(*) Factory setting
Note: Be sure to set unused SW3-1 to OFF.
TERMINAL CONNECTIONS
Connect the unit as in the diagram below.
■EXTERNAL DIMENSIONS unit: mm (inch)
130 (5.12)
27.5 (1.08) 109 (4.29) POSITIONING
GUIDE

R3-DA64A
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: [phone] Fax: [phone] E-mail: [e-mail]
EM-8412 Rev.5 P. 3 / 4
■CONNECTION DIAGRAM
3A
1A
4A
2A
5A
6A
7A
8A
Di 11
Di 12
COM1
Di 13
Di 14
Di 15
Di 16
Di 17
Di 18
9A
13A
11A
14A
12A
15A
16A
17A
18A
Di 21
Di 22
Di 23
Di 24
Di 25
Di 26
Di 27
Di 28
19A
3B
1B
4B
2B
5B
6B
7B
8B
Di 31
Di 32
Di 33
Di 34
Di 35
Di 36
Di 37
Di 38
9B
13B
11B
14B
12B
15B
16B
17B
18B
Di 41
Di 42
Di 43
Di 44
Di 45
Di 46
Di 47
Di 48
19B
3A
1A
4A
2A
5A
6A
7A
8A
Di 51
Di 52
COM5
Di 53
Di 54
Di 55
Di 56
Di 57
Di 58
9A
13A
11A
14A
12A
15A
16A
17A
18A
Di 61
Di 62
COM6
Di 63
Di 64
Di 65
Di 66
Di 67
Di 68
19A
3B
1B
4B
2B
5B
6B
7B
8B
Di 71
Di 72
COM7
Di 73
Di 74
Di 75
Di 76
Di 77
Di 78
9B
13B
11B
14B
12B
15B
16B
17B
18B
Di 81
Di 82
COM8
Di 83
Di 84
Di 85
Di 86
Di 87
Di 88
19B
BUS CONNECTOR
INTERNAL POWER
INTERNAL BUS A
INTERNAL BUS B*
*For dual redundant communication.
Exc. Supply
Exc. Supply
Exc. Supply
Exc. Supply
Exc. Supply
Exc. Supply
Exc. Supply
Exc. Supply
COM2
COM3
COM4

R3-DA64A
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: [phone] Fax: [phone] E-mail: [e-mail]
EM-8412 Rev.5 P. 4 / 4
COM1
Di 11
Di 18
PNP Connectio NPN Connection
+–
9A
1A
8A
COM7
Di 71
Di 78
+–
9B
1B
8B
COM8
Di 81
Di 88
+–
19B
11B
18B
COM1
Di 11
Di 18
+–
9A
1A
8A
COM7
Di 71
Di 78
9B
1B
8B
COM8
Di 81
19B
11B
18B
+–
+–
Di 88
■ Input Connection Examples
INPUT CONNECTOR (40 pins)
■CN1
PIN NO. ASSIGNMENT PIN NO. ASSIGNMENT
1A Di 11 1B Di 31
2A Di 12 2B Di 32
3A Di 13 3B Di 33
4A Di 14 4B Di 34
5A Di 15 5B Di 35
6A Di 16 6B Di 36
7A Di 17 7B Di 37
8A Di 18 8B Di 38
9A COM1 9B COM3
10A No Connection 10B No Connection
11A Di 21 11B Di 41
12A Di 22 12B Di 42
13A Di 23 13B Di 43
14A Di 24 14B Di 44
15A Di 25 15B Di 45
16A Di 26 16B Di 46
17A Di 27 17B Di 47
18A Di 28 18B Di 48
19A COM2 19B COM4
20A No Connection 20B No Connection
■CN2
PIN NO. ASSIGNMENT PIN NO. ASSIGNMENT
1A Di 51 1B Di 71
2A Di 52 2B Di 72
3A Di 53 3B Di 73
4A Di 54 4B Di 74
5A Di 55 5B Di 75
6A Di 56 6B Di 76
7A Di 57 7B Di 77
8A Di 58 8B Di 78
9A COM5 9B COM7
10A No Connection 10B No Connection
11A Di 61 11B Di 81
12A Di 62 12B Di 82
13A Di 63 13B Di 83
14A Di 64 14B Di 84
15A Di 65 15B Di 85
16A Di 66 16B Di 86
17A Di 67 17B Di 87
18A Di 68 18B Di 88
19A COM6 19B COM8
20A No Connection 20B No Connection