M-TI FREEDOM MICRO User manual
FREEDOM MICRO®INSTALLATION GUIDE
1
FREEDOM MICRO UNIVERSAL BRACKET
MTI P/N 063-00369 rev B ©2021 MTI All Rights Reservedwww.MTIGS.com | T:800.426.6844
1
3
2
4
Loosen the bracket arms with the Double Sided System
Tool via the access holes on the back and pull the
bracket arms out.
For new brackets, peel clear lm off of NanoGrip. If
reusing bracket, nano-grip can be cleaned with water
and a soft cloth.
Place device in the bracket and press down for
NanoStick to hold in place.
Adjust the brackets to t the device.
-CONTROLLED DOCUMENT- 063-00369 B-0 Status: Approved ECO-112005
ECO-112005
FREEDOM MICRO®INSTALLATION GUIDE
2
FREEDOM MICRO UNIVERSAL BRACKET
MTI P/N 063-00369 rev B ©2021 MTI All Rights Reservedwww.MTIGS.com | T:800.426.6844
87
65 Insert puck without VHB and tighten the 2 captive
security fasteners to either side of the puck. If using
retrot lockdown bracket, insert puck, then proceed to
steps 7 and 8.
If using the retrot position bracket, dock the puck,
and tighten the 2 captive security fasteners to either
side of the puck through bracket stirrup.
Tighten the bracket arms with the Double Sided System
Tool via the access holes on the back. Squeeze arms
together while tightening screws to ensure a snug t.
Insert the AirTether™ dovetail into the puck and dock
the puck/bracket/device assembly on the riser.
Puck is installed
without VHB.
Check mounting screws monthly to ensure
they have not loosened up due to use.
Check arms monthly to ensure they are tight.
Arms may work loose over time with use.
-CONTROLLED DOCUMENT- 063-00369 B-0 Status: Approved ECO-112005
ECO-112005
Table of contents
