MA grandMA3 User manual

1
Hint:
The grandMA3 I/O Node can be connected with the power cable. Only the grandMA3 I/O Nodes DIN-Rail need to be
installed on the rail following DIN EN 60715 and the instructions below.
Important:
Install the grandMA3 I/O Node DIN-Rail horizontally so that the input terminal is located at the bottom.
Warning:
In order for the device to dissipate heat, comply with a minimum distance of 30 mm (approx. 2 inches) above and
beneath the grandMA3 I/O Node DIN-Rail.
1
Installation

1
1. Install the grandMA3 I/O Node DIN-Rail onto the rail.
Place the grandMA3 I/O Node DIN-Rail on the rail.
2

1
Snap into place
2. Build the I/O Node DIN-Rail into the switchboard.
3

1
Connections
Connect with electrical grid
-or-
4

1
Connect via PoE
Power
Connector MC 1.5/ 3-ST1-5.08
Rigid cables 0.75 mm² - 1.5 mm² (18-16 AWG)
Flexible cables 0.75 mm² - 1.5 mm² (18-16 AWG)
Wire end sleeves are permitted.
Wire stripping length 7 mm
Tightening torque 0.22 Nm - 0.25 Nm
5

1
MIDI & LTC
Connector FK-MC 0.5/ 3-ST-2.5
Rigid cables 0.14 mm² - 0.5 mm² (26-20 AWG)
Flexible cables 0.14 mm² - 0.5 mm² (26-20 AWG)
Wire end sleeves are permitted.
Wire stripping length 8 mm
DC Remote
Connector FK-MC 0.5/ 7-ST-2.5
Rigid cables 0.14 mm² - 0.5 mm² (26-20 AWG)
Flexible cables 0.14 mm² - 0.5 mm² (26-20 AWG)
Wire end sleeves are permitted.
Wire stripping length 8 mm
6