Magnavox 9MDPF20 - Dvd-video Player Operating manual

There are many ways to connect your newTV/DVD to your other equipment.This Quick-Use
Guide shows the easiest, most common connections for the TV/DVD.
AUDIOOUT
DC13.2V
L
R
COAXIAL
ANT.
ANT.
IN
OUT
ANT.
OR
2
3
ANTENNA or
CABLETV SIGNAL
CABLE BOX
CABLETV SIGNAL
4
RF COAXIAL
CABLE
1Disconnect all equipment from the power outlets. Connect the equipment to the power outlets
only after you have finished hooking up everything. Never make or change connections with equipment
connected to the power outlet.
2If you do not have a Cable Box, simply connect your Antenna or Cable TV signal directly to the
ANT(enna) jack on the rear of theTV/DVD.
3If you do have a Cable Box or Satellite Receiver, first connect the CableTV or Satellite signal to
the IN jack on the Cable Box or Satellite Receiver. Then, use an RF coaxial cable (not supplied)
to connect the OUT jack of the Cable Box or Satellite Receiver to the ANT(enna) jack on the
TV/DVD. To view any channel, set the TV/DVD to the output channel of the Cable Box or Satellite Receiver
(channel 3 or 4).Then, select channels at the Cable Box or Satellite Receiver.
4When all connections are complete, plug the power cord of the TV/DVD into an active power
outlet.
5Press the STANDBY-ON 2button on theTV/DVD or its remote to turn on the TV/DVD.
The first time you turn on theTV/DVD, you should complete the TV/DVD setup. See the
other side of this Quick-Use Guide for details.
Quick-Use Guide
Quick-Use Guide
9MDPF qug 20/03/2003 10:24 AM Page 1

Playing a Disc
1Press STANDBY-ON 2to turn on theTV/DVD.
2Press EJECT /to open the disc tray. Put a Disc
in the tray with the label facing up and the shiny side
facing down.
3Press PLAY Bto close the tray. Playback may
start automatically. If not, press PLAY Bagain.
If a DVD Disc menu appears, use the 1 234, ENTER, or
Number buttons to select features or start playback.
Follow the instructions in the menu.
4To stop playing the Disc, press STOP 9.
9MDPF20 / 8239 300 27161
Setting Up the TV/DVD the First Time
1Press STANDBY-ON 2to turn on theTV/DVD.
2Press ENTER repeatedly to select English, French,
or Spanish as the language for TV/DVD setup menus.
3Press 3or 4to select AUTO PRESET.Then press
ENTER to set up TV channels. When setup is
complete, the lowest TV channel will appear on the
TV/DVD.
4To watchTV, press the CH. 3or 4buttons to
select memorized channels. Remember, if you are using a
Cable Box or Satellite Receiver, set the TV/DVD to
channel 3 or 4. Change channels at the Cable Box or
Satellite Receiver.
- SET UP-
2 LANGUAGE
[ENGLISH] ESP FRA
AUTO PRESET
Playable Discs
The TV/DVD will play the following Discs.
DVDs must have a Region Code of ALL regions or Region 1.
DVDs must be recorded in the NTSC Color System.
1
ALL
Recordable
ReWritable
2-3
14
Quick-Use Guide (cont’
Quick-Use Guide (cont’d) d)
12
3
4
9MDPF qug 20/03/2003 10:24 AM Page 2