mailcoms 1E42 User manual

Continue reading below
Right, let’s get your Printer up
and running quickly…
Let’s start by opening and unpacking the box that contains your
Parcelsend Kit 1E42 Printer on the next page.
Parcelsend Kit - Printer
Installation Instructions
1E42 Printer - Windows Installation
Read Now BEFORE you unpack your equipment

Decide whether you will be connecting your printer via a USB cable or a Network
connection.
If you are connecting via USB please continue below at step 3.
If you are connecting via a Network please go to step 9 to complete
your set up.
45
Opening the box and
unpacking
find in your box. Here’s a diagram and explanation of the items you should
Please select the correct power cable for your location.
online help
1
If you have any problems during this installation, refer to the
available.
Printer
USB Power Cord
Network Cable
(for network
installation only)
Connecting via USB or Network?
2
3
Ensure you have the correct power cord for your region.
Connect the power cord and adapter to your printer (as shown) and switch on.
Connecting the Printer via USB
Printer Ready
Wait for approximately 45 seconds until the green light remains constant and
the printer is ready.
4

Note- Ignore any Windows errors that may occur at this time and continue
with Step 9.
8
Your Printer is now connected.
To test your printer is working correctly follow the steps below-
On a PC
Go to your Control Panel
Select Devices & Printers
Double click on the Printer
(DataMax-O’Neil w1110)
Select Printer from the menu bar
Select Printer Properties
Select General
Select Print Test Page.
Congratulations! You have completed your USB
setup.
Downloading the Printer Driver
Ensure you are signed into SendPro® and click on the Help icon.
Select the Datamax Printer Driver
Select to download the correct printer driver for your operating system.
Select Run or Open dependant on your browser.
Accept the licence agreement and follow the on screen prompts to
install. Select Datamax-O’Neill1110
Continue to follow the on-screen prompts and click Finish/ Close.
Note- You may need to check your downloads folder to install Printer Drivers.
7

Aligning the Label Roll
Press the button and check that the label feeds out correctly.
Note- If the label does not feed correctly please refer to label alignment
instructions inside the printer top cover.
Tear off the correctly dispensed label.
5
6Connecting the USB Cable
Connect your printer to your computer with the USB cable.
Test Print

Aligning the Label Roll
Press the button and check that the label feeds out correctly.
Note- If the label does not feed correctly please refer to label alignment
instructions inside the printer top cover.
Tear off the correctly dispensed label.
11
Printing a System Report
Print the System Report to obtain the IP address assigned to the label printer.
1. To print the System Report Simultaneously press the button on the front of the
label printer and the recessed button on the back of the printer with a suitable
object such as a pencil or similar.
2. Keep the printed report that will be needed later in the installation process.
12
9
Connect your Network cable to your printer and Network socket.
Ensure you have the correct power cord for your region.
Connect the power cord and adapter (as shown) to your printer and switch on.
7.
Wait for approximately 45 seconds until the green light remains constant and
the printer is ready.
10
45
Network Cable Power Cable
Connecting the Printer via
Network
Printer Ready

Specifying a Port
Select Create Port
15
Then Select TCP/IP Port and click New Port.
Ensure you are signed into SendPro® and click on the Help icon.
Select the Datamax Printer Driver
Select the correct printer driver for your operating system.
Select Run or Open dependant on your browser.
Accept the licence agreement and follow the on screen prompts to install.
13 Downloading the Printer Driver

14
Select Network and press Next.
Then select Datamax-O’Neill1110 Printer model when prompted and select Next.
Connecting to the Printer