
1
1. Top view of the detector case
2. LED indicator
3. Bottom view of the detector case
4. On/off button
5. Sensor contacts
22
5
5
43
Carefully select the installation location of the MAKS
Water detector.
The device should not be placed:
1. Outdoors or in areas with unacceptable humidity and
temperature
2. In places with a high level of radio interference
3. Near objects that can cause radio signal attenuation
or shielding (metal, mirrors, etc.)
4. At a distance of less than 1 m from the security center
Excellent connection - LED indicator flashes green
Satisfactory connection - LED indicator flashes yellow
Poor connection - LED indicator flashes red
No connection - LED indicator flashes red quickly
In test mode, the unit's radio transmitter operates at
medium power.
Functional parts of the device
Selecting the installation location
Installation and connection
Registration and setup
1. Place the detector at a distance of no more than 2 m
from the MAKS PRO security center. The registration
runs at the lowest possible power to avoid the
influence of neighboring systems which can be being
set up nearby.
2. Start the MAKS Setup application
3. Follow the instructions of the application to connect
to the MAKS PRO and start the registration of MAKS
wireless devices
4. Turn on the MAKS Water, after 10-20 seconds it will
be registered
5. Set up a new device in your mobile application
6. Put the detector on a horizontal surface near the
possible water leakage place.
Switching on and off
Press button 4 to turn on the device - the indicator will
be on. If the device is registered in the MAKS PRO, it
switches to standby mode. If the sensor is not
registered, it will switch to sleep mode after 30 seconds.
To turn off the device, press and hold button 4for 5
seconds.
Attention! If the device is incorrectly installed or flipped,
the accelerometer will be triggered and alarm notification
to the MAKS PRO will be sent.
Indication in communication test mode
Battery replacement
1. Unscrew case back cover 3
2. Carefully remove the upper part of case to prevent
damage of the sealing silicone gasket
3. Replace the batteries and reassemble the device