Mammoth Elite 480L SA User manual

Two Person Assembly
Assembly Instructions
Zip the wall panel to the roof and base.
Fit equipment hanger ends to poles.
Position equipment hangers as required.
Step 5
Step 6
Equipment Hangers
Upper Equipment Hanger
Lower Equipment Hanger
Blue Pole
x15
Parts List
3-Way
Corner
x8
Equipment
Hanger Ends
x16
Yellow Pole
x42
Support Pole
Rubber Foot
x3
Support Pole
Rubber Top
x3
Straight Pole Connectors x6 Centre Securing Ring x3
4-Way
Join
x16
Black Pole
x15
Assembly Guide
Elite 480L 600L SA
Mammoth
Connect wall panel zip to the roof
and base zips starting
(under Velcro flaps).
Equipment
Hanger End
mammothtent.nl
Elite 480L 600L SA

Organise poles and connectors into their colours and groups.
Unzip and lay out tent.
Locate floor section and lay flat with edge sections vertical.
Assemble floor poles and 3-way corners and 4-way Joins as shown.
Ensure Velcro flap is in front right corner.
Step 1
Step 2
Step 3
Step 4
Insert lower wall poles (chamfered end) into 3-way corners and 4-way Join.
Insert upper wall poles (shrunk end) into lower poles.
Fit 3-way corners and 4-way joins on top.
Velcro Flap
4-Way Join
3-Way Corner
4-Way Join
3-Way Corner
ring
Straight Pole
Connectors
Centre
Securing Ring
Insert ceiling poles into 3-way corners and 4-Way joins.
Fit centre securing ring over pole before fitting to 4-way join.
Fit centre ceiling poles into straight pole connectors.
Fit support poles.
Fit roof ensuring Velcro
flap is in front right corner.
Velcro Flap
Support Pole
Rubber Ends