Dancover Pagoda 4x4m User manual

20-08-2018
for
Pagoda 4x4m
Manual

Safety Advice
Attention
In some countries approval is needed to set up a marquee/tent larger than 75 m2. It is your
responsibility to comply with local rules and regulations and to ensure that the marquee/tent is
assembled correctly.
In case of bad weather conditions, it is your responsibility to ensure the marquee/tent is safely
secured and that the marquee/tent does not cause damage to others.
Do not use open re, welding equipment or other sources which can ignite, inside or close to the
tent.
The marquee/tent must be safely secured. We recommend you secure your marquee/tent with
straps and pegs as soon as it is assembled.
Make sure to check if the marquee/tent is covered by your home contents insurance.
Marquees/tents must be evacuated under extreme weather conditions.
In the event of snow, always remove snow from the roof of the marquee/tent regularly to prevent
snow from building on the roof, as heavy snow can cause the marquee/tent to collapse.
In the event of rain, there is a risk of rain puddles building up on top of the roof of the marquee/
tent. Heavy rain puddles can cause the roof to collapse. It is your responsibility to ensure rain
puddles do not build up. As a precaution, make sure the roof of the marquee/tent is stretched
out properly and adequately over the side frames of the marquee/tent and remove rain water
regularly.
Do not unpack or repack your marquee/tent in freezing temperatures. In case of temperatures
below zero, always unpack and repack your marquee/tent indoors to avoid the risk of cracking
parts.
The marquee/tent must be totally dry before you repack and store it to avoid mildew.
Note: Marquees are intended for events and other arrangements and are as such only meant for
short term temporary assembly and the following disassembly. Dancover warranty applies only
to the normal use of the Product, normal wear and tear excepted, in accordance with written
use instructions or manual. The warranty does not apply to damage caused by accident, abuse,
misuse, or modication of the Product.
Warranty Information
Please visit dancovershop.com for information on warranty.
Please always check our website for the latest safety advice and manual.

Part List
Part NO. Part 4x4m
14
24
3 8
4 8
5 4
6 4
7 4
8
10
11
1
1
4
12 8
13 8
14 4
15 60
17 64
20-08-2018

Part List
19 M30 1
20 1
21 3
22 1
23 1
24 4
25 4
20-08-2018

Assembly
Step1: Lay out and connect the square as shown above.
Step2: Fasten the connections.

Assembly
Step3: Set up the top as shown above. NO.1 and 11 assembled by
NO.5.
Step4: Put NO.10 through the top rings (NO.8)
Step5: Put the roofcover (NO.23) on the roof structure.
Step6: Use the legs to raise the top one side at a time.
Step7: Secure the legs to the ground with the stake pegs (NO.13).
Step8: Fasten roofcover (NO.23) with bungee balls (NO.17).
NO. 20
4
12

Assembly
Step9: Use NO. 20 to tighten the roofcover as shown above and
fasten with NO.19.

Contact information
Head office:
Dancover A/S
Nordre Strandvej 119 G
3150 Hellebæk
Denmark
For more information
please visit:
www.dancovershop.com
National contact
Denmark: 70 26 76 20
[e-mail]
UK: 020 8099 7570
[e-mail]
Spain: 911 436 828
[e-mail]
Italy: 02 479 21 198
[e-mail]
Germany: 041 0266 7040
[e-mail] Switzerland: 0840 000125 [e-mail]
France: 0975 181 800
[e-mail] Austria: 0662 626935 [e-mail]
Sweden: 040 233 262
[e-mail]
Finland: 0 931 581 720
[e-mail] Nederland: 0 858 880 524 [e-mail]
Poland: 22 300 8602
[e-mail] Ireland: 0 151 33 003 [e-mail]
Luxembourg: [phone]
[e-mail]
Portugal: 308 800 899
[e-mail]
Belgium: 0 28 08 08 09
[e-mail]
Norway: 231 00 690
[e-mail]