Manamed PlasmaFLow TOTAL JOINT KIT User manual

TOTAL JOINT KIT
www.ManaMed.Net

1
1
00
10 10
30 30
50 50
70 70
90 90
110 110
130 130
00
10 10
30 30
50 50
90 90
70 70
110 110
2 3 4
1
1
3
Right Leg Pictured
Right Leg Left Leg
CALF CUFF APPLICATION
Wrap the cuff around the calf and secure the Velcro to hold it in place.
Make sure the wrap is snug, but not too tight.
Check the parts. (A) Pump with tube, (B) Compressor
device, (C) EZ ROM Ice Pack. Refrigerate the (C) EZ
ROM Ice Pack for at least two hours prior to usage.
Place EZ ROM Ice Pack on the inside of Compressor
device after refrigeration. Connect the tube to the
ON/OFF switch and turn “ON” the switch.
Position the Compressor device so the hole appears
at the knee joint. Wrap the velcro straps to secure
in place. For best results; ON for 5-10 minutes, OFF
for 5-10 minutes.
To adjust flexion and extension control, remove the
pins to the desired settings of your prescribing
physician.
CORRECT PLACEMENT
When both wraps are secured on your legs,
they should look like the picture above.
TURNING THE DEVICE ON
When the wraps are secured on your legs PRESS the power button
for three seconds until the blue light is illuminated on each unit.
1
4
PATIENT DEVICE USE
Unit will inflate and deflate to the specified
mode as directed by your physician.
1
5
SWITCH MODES
For instructions on how to switch between modes,
please refer to “Instructions” section on this page.
H
O
L
D
H
O
L
D
F
O
R
3
S
E
C
O
N
D
S
2
QUICK START
™
QUICK START
2
QUICK START
5240 W Charleston Blvd.
Las Vegas NV 89146
(B)
(C)
(A)
510
510
ON
~
OFF
~
Order information
Part Number: TJK001
Contents:
PlamsaFlow, ManaFlexx2, EZ ROM
How to order
Email: [email protected]
Fax: [phone]
Call: 888-508-0712
1
Snap Controller onto Pad
2
Apply ManaFlexx2 to body
as recommended by physician
3
Turn on/off controller by pressing
the “Power” icon on controller
4
Increase intensity by pressing
the “ + ” button. Intensity level
indicated by the number displayed.
5
Decrease intensity by pressing
the “ - ” button. Intensity level
indicated by the number displayed.
6 7
Leave the patch in place for up to
12 hours while the device is turned
off automatically or manually.
For quad atrophy, it may be recommended
to place the electrode like the image above.
Consult your healthcare professional
for more information.