Manhattan 422840 User manual

LCD WaLL Mount
QuICK InStaLL GuIDE
Model 422840
MH-422840-miniQIG-1009-03
Thank you for purchasing this MANHATTAN®LCD
Wall Mount, Model 422840.
Fully adjustable tilt, rotate, side-to-side and tension
settings allow a single LCD display to be reliably
secured and positioned for a comfortable viewing
position. Instructions are on the back of this sheet.
MANHATTAN®offers a complete line of PC Components, Peripherals, Cables and Accessories.
Ask your local computer dealer for more information or visit us online at
www.manhattan-products.com
Copyright © MANHATTAN
All products mentioned are trademarks or registered trademarks of their respective owners.
GENERAL
• Fits 75 x 75 mm / 100 x 100 mm
VESA-compliant monitors up to 22”
• Monitor weight capacity: up to 15 kg
(33 lbs.)
• Installs approximately 2.5 cm (1 in.)
from most vertical surfaces
DIMENSIONS
• Bracket dimensions: 7.6 x 7 cm
(3 x 2.75 in.)
• Mount clearance, 12.7 cm (5 in.)
• Weight: 338 g (0.85 lbs.)
PACKAGE CONTENTS
• LCD Wall Mount
• Installation hardware with instructions
SPECIFICATIONS
•Securely holds one LCD monitor
on wall to improve views, increase
work space and minimize clutter
•Two-piece bracket with heavy-duty, steel construction
easily mounts to most vertical surfaces
• Meets VESA standards — ts monitors up to 22” and up to
26 pounds
•Lifetime Warranty

ASSEMBLY INSTRUCTIONS
Bracket-mounting
anchors and screws
(2 ea.)
Mini-level
Display-mounting screws (4)
Always handle the LCD monitor with care during assembly
of this LCD Wall Mount. Disconnect any cords or cables
that could otherwise interfere with the placement of any
of the components, and make sure that any screws and
bolts are properly tightened to prevent possible damage to
the monitor or nearby items. After assembly, periodically
check the ttings to ensure no slippage or loosening has
occured that could result in monitor damage.
1. Check that the package contains the components
shown here.
2. Using the mini-level
as shown, position
the wall bracket
against the vertical
mounting surface
and mark the
positions of the two
bracket holes.
Punch or drill pilot/
starter holes, if/as
needed, then use
either the 2 bracket-
mounting anchors or
screws included in this
package to secure the bracket
to the vertical surface.
3. Making sure
the wall mount
is right-side up
(to t into the
wall bracket),
align the holes
in the display
bracket with
those on the
LCD monitor
and secure
the monitor
to the bracket
using the four
display-
mounting
screws.
Wall mount
with bracket
æ
4. Slide the wall mount with monitor attached into the bracket
already secured to the vertical surface, then tighten the
wall bracket screw (it should align with the center hole,
as indicated).