Map KF150 Installation manual

Programming
instructions for KF150
Key blade requires cutting
by your local locksmith.
Programming in a 3rd (or more) key:
1. Insert Old Key ‘A’into the ignition and
turn to the ‘I’(Acc) position.
2. Turn Old Key ‘A’to the ‘0’(Off) position
and remove key.
3. Inset Old Key ‘B’and turn to the ‘II’(On)
position.
4. Turn Old Key ‘B’to the ‘0’(Off) position
and remove. The Door locks will
sequence.
5. Inset the new key and turn to the ‘II’
(On) position. If performed correctly, the
door locks will sequence 3 times to show
successful programming.
6. Turn the new key to the ‘0’(Off) position
and remove from the ignition.
Programming in a first or second key:
1. Important Note: At least two keys have to
programmed to the vehicle.
2. Programming needs to be done via a
compatible scan tool.

Programming Remote Control:
All remote controls must be present during the below process. Any old remote controls that are not
present will no longer function.
1. Ensure all doors + boot is closed.
2. Sit in driver’s seat (with door closed)
3. Insert key into the ignition and turn to the ‘I’(Accessories) position.
4. Press the rear demister button 3 times within 4 seconds –if performed correctly, the door locks will
sequence. You are now in learn mode.
5. Press the lock button on the new remote.
6. Press the lock button on any old remote controls.
7. Once you have finished programming, turn the key to the ‘0’(Off) position and remove the key.
Tips:
4. Try pressing the rear demister button 3 times rapidly.
Warning! This remote contains a button/coin cell battery. If swallowed, a lithium battery can cause severe or fatal
injuries within 2 hours. Keep batteries out of reach of children. If you think batteries may have been swallowed or
placed inside any part of the body, seek medical attention immediately.