
2
3. Once congured, replace the lid.
►Switch 1 and 2 sets the sound mode combination.
►Switch 3 sets the sound level.
• Up - high volume
• Down - low volume
Alarm Like Mode (suggested mode)
Two Alternating Tones
Randome Tones and LED Blinking
Silent, Only LED Blinking
Siren Mode Siren Mode
Down
Down
Up
Up
Switch 1Switch 1
Down
Up
Down
Up
Switch 2Switch 2
1. Remove the lid by pressing both buttons on each side of the Gady.
2. Use the following table to set the mode switches:
HARDWARE SETUP
►Both indicator lights will briey
ash.
►After 10 second delay, the
indicator light will ash again.
►Device will emit a sound.
2. Turn on the Gady by pressing the power
button on the side.
►South-facing, ideally where it
will be exposed to sunlight for
charging.
1. Mount the Gady in the desired location.
MOUNTING AND STARTUP
Always wear ear protection when in the
vicinity of the speaker! Never hold device
close to yours or anyone else’s ears! The
speaker can produce noises exceeding
105DBA (range 1-5KHZ).
This device includes 1 LiFePO4 rechargeable
battery, MAX 3.6v. If desired, a 3V non-
rechargeable, size RCR123A battery can be
substituted. When using Gady with a non-
rechargeable battery, the solar panel must be
disconnected to reduce damage.
POWER
The Margo Gady is a motion activated wildlife deterrent with a built-in speaker that
emits noises specically designed to scare animals in it’s vicinity. The Gady is able to
detect movement from 10m (30ft) away.
ABOUT