Martin Yale 2051 SmartFold Programming manual

2051 SmartFold™
Quick Start Instructions
1
5
4
3
2
Setting up t e Mac ine
Fold Table Installation
Loading t e Paper
Setting a Paper Size, Fold Type, and
Quantity
Folding Paper
"For important safety instructions and warnings, refer to t e
User Manual."
Folding Paper
ressing the "RUN" button will initiate folding. Folding will continue until one of
the follow conditions is met:
1. The Stop button is pressed,
2. The Feed Table becomes empty of paper,
3. A folding error is encountered, or
4. The programmed quantity reaches 0 (zero).
Setting a Paper Size, Fold Type, and
Quantity
ress the "SIZE SELECT" button located on the operator interface to specify your
paper size.
ress the "FOLD SELECT" button and choose the fold type you wish from the
selection.
ress the "QUANTITY" button, input the numbers of pages to fold, and
then press the enter button.
You are now ready to begin folding paper.
4
5
In case of emergency, press the "STOP" button to
automatically stop the machine.
Operator Interface
Fold
Types
Incremental
Adjustment Stack
W eels
2nd Fold
Table
1st Fold
Table
Folder
Speed
Run
Stop
Display Contrast
Test
Enter
Clear
Entry
Quantity
Custom Paper
Lengt
Size Select
Fold Select
Paper Sizes
Memory
Control
Display
M-S027126 Rev. 2 8/16/13

Feed
Table
Extension
De-jam ort
Operator Interface
Exit
Conveyor
1st Fold Table
Top Cover
De-jam Handle
Storage
2nd Fold
Table
Extension
1Setting up t e Mac ine
Remove your 2051 AutoFolder from the box & place it on a flat, sturdy table or
work surface. Attach the ower Cord to the ower Connection on the machine
and plug into an AC outlet.
ower Connection
Fold Table Installation
Step 1: slide the front slot opening of the fold table onto the inner set of pins
(closest to the folding rollers).
Step 2: lower the fold table onto the outer set of pins. Repeat Steps 1 & 2 for
2nd Fold Table installation (see illustration below).
Table Extensions
Step 3: align the locking tabs of the Table Extension with the slots in the Feed
Table. Squeeze the Feed Table and Table Extension together nearest the tabs
and slots until the 2 pieces snap together. Repeat step 3 for Conveyor Table
(see illustration above).
2
Loading t e Paper
To load paper into the Feed Table, push the Feed Table down, until it locks into
the "load" position as shown.
Load the paper into the Feed Table. Unlock the Feed Table to return to the
raised position by depressing the Feed Table Release (see illustration above).
3
USH HERE ON FEED TABLE
TO LOCK INTO LOAD OSITION
LOAD OSITION
FEED TABLE RELEASE