6 Mania EFX500 & EFX600 user manual
Protecting yourself and others from electric shock
and injury
• Ensure that the fixture’s voltage setting matches your local AC power
supply before applying power.
• Disconnect the fixture from AC power before removing or installing the
lamp, fuse, or any part, and when not in use.
• Always ground (earth) the fixture electrically.
• Use only a source of AC power that complies with local building and
electrical codes and has both overload and ground-fault protection.
• Do not expose the fixture to rain or moisture.
• Refer all service not described in this manual to a Martin service
technician.
• Do not operate the fixture if any covers or components are missing,
damaged or deformed.
• Do not use the product if the power cable is damaged. Replace the
cable with a Martin item only (available from your Martin dealer).
Protecting yourself and others from burns and fire
Warning! Hot lamp. The exterior of the fixture can become hot. Allow to
cool for at least 10 minutes before handling or opening.
• Surface temperature under steady state condition = 100°C (212° F).
• Do not operate the fixture if the ambient temperature (Ta) exceeds 40° C
(104° F).
• Never attempt to bypass the thermostatic switch or fuses. Always
replace defective fuses with ones of the specified type and rating.
• See serial label for replacement fuse size and lamp type.
• Keep all combustible materials (for example fabric, wood, paper) at
least 0.3 meters (4 inches) away from the fixture. Keep flammable
materials well away from the fixture.
• Do not illuminate surfaces within 1 meter (3.3 feet) of the fixture.
• Provide a minimum clearance of 0.1 meters (4 inches) around fans and
air vents and ensure that air flow through and around vents is free and
unobstructed.
• Never place filters or other materials over the lens or in the optical path.
• Do not look directly into the light.
• Change the lamp immediately if it becomes damaged or thermally
deformed.
• Do not operate the fixture if any optical components or shields are
missing, damaged or deformed: an unshielded discharge lamp emits
dangerous UV radiation that can cause burns and eye damage.
• Do not modify the fixture or install other than genuine Martin parts.
