MAS MTGS User manual

1
DOOR ACCESS SYSTEM
USER’S MANUAL
MTGS
1. Definition
MTGS is an Access System which allows to open the door by a password to be
entered through a keypad. MAS access systems are suitable for general use, such as
house, office, factory, etc…
2. Features
•Strong metal body.
•3 LEDs to show the state of the unit.
•Operating temperature : -15/60 º C
•A green LED indicates that the system is on stand-by mode.
3. Package contents
•1 Pc User’s manual
•1 Pc access (reader) module MTGS
•1 Pc power supply RBT12
4. Settings
4.1. Open door with password
While the system is on stand-by mode, enter your 4-digit password. The default

2
password set at factory is 1234. If you enter wrong password, the system resumes
back to stand-by mode.
4.2. Change door password
* Press #, watch 3 LEDs blink and go OFF, then enter ADMINISTRATOR
password (The default administrator password set at factory is 3579).
* Press “1” and watch red and green LEDs go ON together then 3 LEDs blink.
* Enter your new 4-digit password.
* Reenter your new 4-digit password after 3 LEDs blink and go OFF.
* When 3 LEDs go ON, your operation is successful.
4.3. Change Administrator password
* Press #, watch 3 LEDs blink and go OFF, then enter ADMINISTRATOR
password (The default administrator password set at factory is 3579).
* Press “2” and watch red and green LEDs go ON together then 3 LEDs blink.
* Enter your new 4-digit password.
* Reenter your new 4-digit password after 3 LEDs blink and go OFF.
* When 3 LEDs go ON, your operation is successful.
NOTE : In case you wait more then 10 seconds during above operations, the
system resumes automatically back to stand-by mode.
4.4. Change door open time
* Press #, watch 3 LEDs blink and go OFF, then enter ADMINISTRATOR
password (The default administrator password set at factory is 3579).
* Press “9” and watch red and green LEDs go ON together then 3 LEDs blink.
* Enter door open time between 1 and 9.
* Reenter door open time after 3 LEDs blink and go OFF.
* When 3 LEDs go ON, your operation is successful.
NOTE : If for any reason, the door open time is set to “0” (zero), the door cannot
be opened even if the correct password is entered.
WARNING : Default User password and Administrator password set at factory
must be changed by the Administrator with new passwords.

3
5. Connection