Massimo E-Spider 72 V Trike User manual

FOREWORD
Thank you for your purchasing GO KART.
This manual covers the main data, basic structure, and main procedures of operation, adjustment,
maintenance and troubleshooting of GO KART. It will help you familiarize yourself with all the
necessary skills so that you will bring your vehicle into full, best play with minimized trouble for a
long service life.
Products are always subject to further improvement, which will cause some difference between
the vehicle and this manual, without future notice.

Installation Guide
The Standard distance between front frame and ground is 125mm.

The height of chassis is adjustable.（Warning: the screw of bearing joint must be tighten,
tighten the screws can’t less than 15mm.)

Camber adjustment method, Front wheel camber standards values is α﹣1°

Front toe adjustment method, Front wheel toe Standard value is 4MM（A＋4MM＝B）

Push the front frame to reach the lowest position, adjust the limit screw beside right front
shock absorption. Make sure the minimum distance between tie rod of steering linkages and
frame is 10mm

CONTENTS
VEHICLE SAFE RIDING………………………………..………….1 PARKING
.....................................................................
16
NOTES FOR SAFETY…………………………………..…………...1 CHECK AND CHANGE OF ENGINE OIL
.................
16
PROTECTING MEASURES………………………………………..2 SPARK PLUG
...............................................................
17
ACCESSORIES…………………………………..…….….…………...2 AIR CLEANER
.............................................................
18
REFITTING……………………………………..……….……………..2 CHECK LEAKS ALONG AIR SUPPLY LINE
............
18
SPECIFICATIONS……………………………………..….… ……….3 THROTTLE OPERATION
.........................................
19
DESCRIPTION………………………………………..…...………….4 IDLE SPEED
.................................................................
19
VIN RECORD……………………………………….……..…………...7 FRONT HYDRAULIC DISC BRAKE…
.......................
21
IGNITION SWITCH………………………………….…..…. ……...8 REAR HYDRAULIC DISC BRAKE
..............................
21
FUEL AND FUEL TANK…………………………….……..............9 CHECK OF BRAKE SYSTEM
......................................
22
LEFT HANDLEBAR CONTROLS…………………………….…10 BRAKELIQUID…
..........................................................
22
SAFETY SWITCH………………………………………..............…10 EXHAUST MUFFLER…
...............................................
23
SPEED-LIMITING DEVICE……………………………..………. 11 BATTERY
........................................................................
24
ENGINE OIL……………………………………………………………11 SELF-RECOVERED OVERLOAD PROTECTOR
.......
26
TYRES…………………………………………………………………....12 TROUBLESHOOTING
..................................................
26
OPERATION GUIDE…………………………… ……..……………13 STORAGE GUIDE
..........................................................
27
STARTING THE ENGINE…………………………………..………13 STORAGE
......................................................................
27
STARTING PROCEDURE BY THE STARTER BUTTON...14 REMOVAL FROM STORAGE
......................................
28
STARTING PROCEDURE BY THE KICK-STARTER………14 MANTENANCE
.............................................................
29
BREAKING-IN……………………………………..…………………..15 MANTENANCE SCHEDULE
........................................
29
RIDING………………………………………………………………...…15 ENGINE MANUAL
........................................................
30

1
VEHICLE SAFE RIDING
WARNING
Vehicle riding requires special efforts on your part to ensure your safety. Know these requirements below before you
fide. For on-road use, this vehicle is designed to be operated only on level, on –road surface, free of obstacles.
Do not operate this vehicle while under the influence of alcohol or drags. That can impair judgment and result.
Keep a safe distance between your vehicle and other vehicle.
Do not allow your child to ride without your
supervision. The rider must read this manual before
operate.
Never run the engine in closed area. The exhaust gas contains poisonous carbon monoxide gas(CO).
During driving, do not touch exhaust muffler, engine etc to refrain from scald, for its temperature is
high.

2
PROTECTIVE THINGS
1. Most atv accident fatalities are due to head injuries. Always wear a helmet. You should also wear a face shield and
protective clothing.
2. The exhaust system becomes hot during riding, and it remains hot for a while after stopping the engine. Be careful not
to touch the exhaust system since it is hot. Wear clothing that fully covers your legs.
3. Do not wear loose clothing that could catch on the control levers, kick-starter, footrests or wheels.
REFITTING
WARNING
Refitting of the atv or removal of original parts may make the vehicle dangerous or illegal. Obey all national and local
equipment regulations.
ACCESSORIES
Genuine accessories by our Co. have been specifically designed and tested on the atv. Because our Company won’t test
accessories manufactured by other companies, you are personally responsible for selection, installation, and use of them.
Always follow the guidelines below:
1. Carefully inspect the accessory to make sure that it does not obscure any lights, reduce ground clearance and banking
angel, or limit suspension travel, steering travel or control operation.
2. Accessories may increase the time that hands or feet operate controls, resulting in increased reaction time in an
emergency.
3. Do not add electrical equipment that will exceed the vehicle’s electrical system capacity.
4. Do not add device cooling the engine.

3
SPECIFICATIONS
E3000
Length
2680mm
battery capacity
72V50A
Width
1670mm
Battery Type
3.7V ternary lithium battery
Height
770mm
Charging time
1-4H
Ground clearance
125mm
Endurance
150KM
Wheel base
1670mm
Type size (front & rear)
185/30-14；
270/30-14
Dry weight
296kg
Start mode
Electric
Max speed
≥80km/h
Clutch
Oil dipped in pieces
Front brake type
Disc-brake
Engine oil
15W/40-SE
Rear brake type
Disc-brake
Engine oil cap
1.1L

4
额定功率Rated power/W
3000
电压 Voltage/V
60/72/84
空载电流 Idle current/A
4.2-7.8
额定转速 rated Rotate speed/RPM
3000-6000
额定扭矩 Rated torque/NM
10-5
额定电流 Rated current/A
50/42/36
电机效率 Motor efficiency
90/%
初级速比 primary Speed ratio
2:1
档位速比 Gear speed ratio
3.27:1 1.94:1 1.35:1 1.04:1
电机相位角Motor phase angle
120°
档位 Gear position
踩四档、勾四档、国际档
Step on 4 gear, check back gear, international gear
离合方式Clutch method
手动/自动Manu/Auto
净重 Net weight/Kg
17

5
Left and right turn signal
Trumpet
charging port
Headlight switch
Double flashing switch
Digital meter
I:reversing switch
switch
Power display

6
Headlight
Reflector
Windshield
Shock absorber

7
Headligh
t
Rear tire
Front tire
Seat slide adjustment
Turn signal

8
VIN RECORD
Please fill the VIN and engine code of your ATV in blank below. They will help order spare parts and find out the vehicle once
stolen.
1. VIN 2.ENGINE CODE
VIN: ☆ □
Engine code: ☆ □
NOTES
1. The VIN is stamped on the rear fork.
2. The engine code is stamped on the bottom-left of the engine.

9
IGNITION SWITCH
The ignition switch is situated is situated on the front right of the vehicle body.

10
FUEL AND FUEL TANK
Fuel Selection
Fuel is a key factor in deciding the exhaust emissions amount from the engine, so selection of fuel must follow the rules
below.
Selected fuel must be beakless or low-lead gasoline with No. RQ-90 or higher.
Fuel Tank
The fuel tank capacity is 12L.
WARNING
Lithium battery storage instructions
1. Lithium-ion batteries should be stored in a relatively cool, dry, and ventilated environment, and should be kept away from water, fire and high
temperatures. The storage temperature of the battery must be within the range of -10℃~45℃, and the humidity should be 65±20%RH.
2. Storage voltage and power: voltage is 3.7V~3.9V (4.2V lithium battery standard voltage system, multiple string combinations * corresponding
multiples); power: between 30% and 70%. To
3. Long-term storage batteries (more than 3 months) must be placed in an environment with a temperature of 23±5°C and a humidity of 65±
20%RH .
4. The battery should be stored in accordance with the storage requirements, and the battery should be fully charged and discharged once in 3
months and recharged to 70% of the power.
5. Do not transport the battery when the ambient temperature is higher than 65°C.

11
STEERING WHEEL CONTROLS
Emergency Switch
The switch is set in middle position; to stop the engine.
Starter button
Press the button with the vehicle in braking to start up the engine.

12
CAUTION
It’s better for inexperienced riders to set the top speed lower so as to avoid accident.
ENGINE OIL
The quality of the engine oil plays a vital role in deciding the engine performance and service life. Engine oil must be
selected in accordance with the rules below and other oils are forbidden to be used.
Engine oil recommended: gasoline engine oil Class SAE15W/40-SE or Class SE, SF, SC from API Service Classification.
The vehicle has been filled with the engine oil Class SAE 15W/40-SE class before being been delivered, and the lubricant is
only suitable at a temperature range from +40°C to －10°C. If other motor oil is to be used instead, the alternative must be
technically equivalent in every respect. Viscosity varies with regions and temperatures, so the lubricant has to be selected
according to our recommendation. If the gasoline engine oil Class SAE15W/40-SE can’t be obtained when in need, the gasoline
engine oil No. HQB-10(or No. HQB-6 in regions where the temperature is under －10°C) is available.
Before replacing the lubricant, please drain the oil out completely remaining in the crankcase, and clean the inside by
clean kerosene, then fill new one instead.

13
CAUTION
Running the engine with insufficient oil can cause serious damage to engine.
TYRES
Proper air pressure will provide maximum stability, riding comfort and tire life.
Check tire pressure frequently and adjust if necessary.
Select the right replacement tires in accordance with the specifications shown in the table 1.
Pressure(Kg/cm’2)
Front:1.8
Rear:1.8
Tire size
Front:185/30-14
Rear:270/30-14
NOTE
Tire pressure should be checked before you ride while the tires are cold. Check the tire for cuts, embedded nails, or other
sharp objects.
Check the rims for dents or deformation. See Yom dealer for change of damaged tires or punctured inner babes.
WARNING
●Do not attempt to patch a damaged tire or inner tire, otherwise wheel balance and tire reliability may beimpaired.
●Improper tire inflation will cause abnormal tread wear and create a safety hazard. The tire pressure less than the rated
value may result in the tire slipping on the ground, or coming off from the rim, even the vehicle being out of control.
●Operation with excessively worn tires is hazardous and will adversely affect traction and handling.
●The use of tires other than those listed on the table 1 may adversely affect handling.
When the tread depth in the middle section of tires reaches the limits in table 2 below, please replace tires.
Tread depth limits
Front tire 6.0mm
Rear tire 6.0mm