Match MS 42C User manual

MS 62C I MS 52C I MS 42C
MS
6X
I MS SX I MS
4X
Komponenten-
und
Koaxiallautsprechersysteme
Component-
and
coaxial
speaker
systems
a.
CD
c:
(i)
(')
";j'
-

Dear Customer,
Congratulations on your purchase
of
this high-
quality MATCH speaker system.
This system highlights best quality, excellent manu-
facturing and state-of-the-art technology.
After 30 years
of
experiences
in
research & deve-
lopment
of
audio products this speaker system ge-
neration sets new standards.
We wish you many hours
of
enjoyment with your
new MATCH speakers.
Yours
AUDIOTEC FISCHER Team
General instructions for installing a MATCH 4. The quality
of
the installation has a signi-
ficant effect on the overall performance
of
the speaker system. Treat each installa-
tion step with a high degree
of
attention.
speaker system
To
prevent damage to the speakers and possible in-
jury, read this manual carefully and follow all instal-
lation instructions. This product has been checked
5.
Avoid low frequency cancellation caused
by air leakage between the speaker
basket and the mounting surface (e.g.
mounted on a bended or uneven sur-
face or mounted
in
an oversized hole).
for proper function prior to shipping and is guaran-
teed against manufacturing defects.
For a proper performance and to ensure full war-
ranty coverage, we strongly recommend to get this
product installed by an authorized MATCH dealer.
6.
Mounting panel reinforcement may be ne-
cessary
in
some cases
in
order to ensure a
stable , torsion-free and even surface. This
can be achieved by mounting the spea-
ker on a metal or wooden sub-baffle be-
hind the body
or
door panel. Consult an
installation specialist for further advices.
If you choose to perform your own installation read
the following information and precautions carefully.
Failure to follow the stated precautions may result
in
personal injury and/or damage to the audio system
or
vehicle.
1.
Always make sure that the speaker will fit into
the intended mounting location and that there
is adequate depth for the magnet system.
2.
Check for adequate space between spea-
ker and window, window crank, power win-
dow mechanism, seat, rear deck torsion
bars, and other items which may interfere
with the speaker's mounting. This is very
important if any hole cutting is required.
Detailed size information is indicated
in
the dimension section
of
this manu-
al. Take care that the mounting sur-
face is flat and free from all obstructions.
3.
Do not mount the speakers where water may
splash on them.
7.
In
most cases you can use the original spea-
ker mounting locations at the doors, body pa-
nels or the rear deck. Ifthese are not available
you have to prepare your own secure installa-
tion place. Due to their structural integrity and
accessibility the precut mounting holes should
be used whenever possible.
Important:
Never cut any metal that is an integral part
of
an
automobile's safety or structural car body.
7

8
General instructions for connecting MATCH
speaker systems
We strongly recommend that you operate the com-
plete audio system at low volume before final in-
stallation. This will allow a trial listening test before
securing the loudspeakers into their mounting loca-
tions.
Make sure that all speaker wiring is fully protected
from cutting or wear at sharp edges. This can lead
into a short circuit which might damage your head
unit, amplifier and/or speaker system.
Make sure that all speaker wires have sufficient
length
in
order to reach the speaker terminals wi-
thout stress on the wire or connectors.
Component systems
2-way component system with reduced moun-
ting depth for easy installation
Woofer with high damping coated paper cone
25 mm
I
1"
silk dome tweeter with
neodymium magnet
Separate, compact crossover with high-grade
components and tweeter protection
Grille, cables and mounting material included
in delivery
General instructions for mounting MATCH spea-
ker systems
Once you have tested the complete speakersystem
and have confirmed correct operation, turn off the
audio system and prepare the loudspeaker for final
mounting.
1.
Place the loudspeaker in the mounting positi-
on as shown
in
the illustration ,Mounting the
woofer".
2.
Fix the speaker with its mounting ring in its in-
stallation place and check if all screws are
in
the right position to the fixing holes. Use the
included screw clips to secure the screws.
Tighten all screws evenly.
3.
Attach the mesh to the mounting ring.
Coaxial systems
2-way coaxial system with reduced mounting
depth for easier installation
Woofer with high damping coated paper cone
Integrated tweeter with polymer dome and
neodymium magnet
Grille, cables and mounting material included
in delivery

MS4B
MS4X
445 5
445 84
MS5B
MS5X
475
45
475
71
MS6B
MS6X
58
72
CD
MS1T
~
.........
"
C\j
f\
J
~
1\
J
¢46,5
¢46,5
*All dimensions are noted in mm
9.

Mounting
the
woofer
I
Mounting
the
tweeter
Surface
mount
Flush
mount
Connecting
the
crossover
/~
I
I
::
.....
lH
+
c
I
~~mFITC:H
15
~
~
+
I
I
::z:
=:;
lD
+
~%.
10

Component systems:
Power
handling
RMS
I
Max.
Coaxial
systems:
Power
handling
RMS
I
Max.
165 mm
I
25 mm
6,5"
I
1"
58 mm
I
2,28"
6
I
12 dB slope
40
I
120 Watts
65-22.000
Hz
47,5 mm I 1,87"
6
I
12 dB slope
44,5 mm
I
1,75"
6
I
12 dB slope
,,~,~,~
~"'~'~'
~~=•~w+<<<<~<<<><«<<<U<<<<w~
"~~'""'
~~''~'''"~~~-·'""'f~'~~
~'''
'~"''-"'''
Frequency range
Sensitivity
''
,,
,,
,,,,,,,,.,,,,,,,
,,.
,,,
,,,
,,
.
Impedance
Diameter MT
I
HT
40hms
165 mm
I
20 mm
6,5"
I
0,75"
Installation depth 58 mm
I
2,28"
"''~''''
'''"='"'"'==<<"
""'~+"'''"'''~'""''''
''"''''''""''"''''~''
""'''-"''''"'w''&c
'''"'""'''''"
''"'""'''"'
Crossover
The limited warranty comply with legal regulations.
Failures
or
damages caused by overload
or
impro-
per use are not covered by the warranty.
Please return the defective product only with a
valid proof
of
purchase and a detailed malfunction
description.
Technical specifications are subject to change!
Errors are reserved!
6 dB slope
For damages on the vehicle and the speaker
caused by handling·errors
of
the speaker system
we
can't assume liability.
11

AUDIOTEC
FISCHER
Audiotec Fischer GmbH
Hi.inegraben 26 · D-57392 Schmallenberg
Tel.: [phone]
·Fax:
[phone]
E-mail: [email protected] · Internet: www.audiotec-fischer.com