Spangenberg International B.V. –Nijverheidsweg 19F –3641 RP Mijdrecht –Holland –T. +31 (0) 297 253 969 –F. +31 (0) 297 256 445
info@maximaholland.com - www.maximaholland.com
First Time Use
•Unpack and inspect your machine immediately after receipt. If there are any latent defects or damage to
the machine then immediately contact your dealer. Save all packaging materials in case the machine needs
to be returned or for inspection by the freight carrier.
•Remove any protective film from all surfaces.
•Read this instruction manual completely before attempting to install and operate this product. All
installations and set ups must be done by authorized service agents, your dealer, or Maxima
representatives.
•If your machine is supplied with a factory fitted molded plug then you may plug the unit into a standard
electrical outlet. Make sure that the voltage of the machine and the wall outlet are compatible. If your
machine is not supplied with a factory fitted molded plug then a qualified electrical engineer must be
contracted to wire the unit to the power supply.
•Before using your appliance for the first time it is recommended to clean the appliance according to
instructions mentioned in chapter “Cleaning and Maintenance”.
Installation
1. The machine must be positioned on a flat and stable surface.
2. Choose a surface where the machine is not exposed to direct sunlight, or close to a direct source of heat
such as a cooker, oven or radiator.
3. When positioning the appliance, maintain a distance of 10cm (4 inches) between the appliance and walls or
other objects for ventilation and ease of use.
4. Place the machine away from flammable materials, liquids and gasses. Also, do not store flammable
materials, liquids or gasses nearby.
5. Position the machine in such a way that the plug is accessible at all times.
6. Assemble any parts (if required).
7. Plug the power plug into a grounded and compatible socket.
Operation
•Fill the oil reservoir(s) with frying oil. Make sure the oil level is kept between the low “L” and high “H” mark,
located inside the oil reservoir(s)
•Switch on the appliance by using the “ON/OFF” switch located on the control panel (if required). The green
power indicator will light-up.
•Select the desired temperature using the temperature control dial. The orange indicator will light-up.
•Allow the appliance to reach the selected temperature. The orange will switch of when selected
temperature has been reached.
•Place your product in the basket and gently drop the basket into the oil, then close the lid. Set the timer if
needed, using the timer control dial located at the front (20L & 30L models only).