Maxon CIC Europe CM10 User manual

maxon & EUROPE
Ш 10 Multi European CB Radio
User Manual
maxon
All manuals and user guides at all-guides.com
all-guides.com

User Manual CM10
Spécification................................................................................................................................3
Control and Operation..............................................................................................................4-5
Installation...................................................................................................................................
Installation of Main Unit...............................................................................................................
Installation of Antenna................................................................................................................
Operational Test...........................................................................................................................7
Frequency Bands Table............................................................................................................... 7
Frequency Band Selection............................................................................................................ 7
Reset...........................................................................................................................................8
Table of Restrictions....................................................................................................................9
Updated Information on National Restrictions............................................................................10
Diagrams.............................................................................................................................. 11-13
Decleration of Conformity...........................................................................................................14
User Statement..........................................................................................................................15
Page 2 o f14
Contents
All manuals and user guides at all-guides.com

User Manual CM10
Spécification
GENERAL
Channels ................................
Frequency Range ....................
Frequency Control ..................
Operating Temperature Range
DC Input Voltage ....................
Size ........................................
Weight ...................................
............... 40 Ch AM/FM 4W
....... 2 .5 5 to 27.99125 MHz
....................................... PLL
........................ -10° / +55°C
................... 13.2 V DC ±15%
180(L) X 35(H) X 140(D) mm
................................... 750 g
RECEIVER
Receiving System .......................
Intermediate Frequency .............
Sensitivity ..................................
Audio Distortion..........................
Image Rejection.........................
Adjacent Channel Rejection .......
Signal/ Noise Ratio .....................
Current Drain at standby ............
Current Drain at maximum audio.
...Dual Conversion Super Heterodyne
1st IF: 10. 95 MHz, 2nd IF: 455 MHZ
0.5 |aV for 20 db SINAD in FM mode
.................. Less Than 8% @ 1 KHz
............................................... 5 dB
.............................................. 5 dB
.............................................. 45 dB
............................................150 mA
............................................ 820 mA
TRANSMITTER
Output Power .........
Modulation .............
Frequency response
Output impedance...
Signal/ Noise Ratio.
Current Drain
........
.......... 4W @ 13.2 V DC
....FM: 1.8 KHz ±0.2 KHz
From 400 Hz to 2.5 KHz
.RF 50 ohm Unbalance
.................... 40 dB MIN
...................... 1100 mA
Page 3 o f14
Specification
All manuals and user guides at all-guides.com

User Manual CM10
Control & Operation
Front anel
1. AM/FM Selector
This key allows the user to select the AM or FM operating mode in both RX and TX. The AM/FM
operating mode selection is possible only if it is enabled on the programmed frequency band.
2. CH9/CH19 Selector
This key allows quick access to one of the two pre-programmed emergency channels (CH9 and
CH19). Each time this key is pressed, the radio will select CH9, then CH19, then again the normal
operating channel. When one of the emergency channels is selected, EMG will appear on the LED
display. The operating mode (AM or FM) for the emergency channels is factory pre-programmed.
3. TX Indicator
This red LED indicator lights up when the radio is in transmit mode.
4. FM Indicator
This green LED indicator lights up when the radio is in FM mode.
5. LED Display
The large two-digit LED display indicates the operating channel and the programmed frequency
band code.
6. DN (Down) Key
This key allows selection of the operating channel in decrements. By keeping this key pressed,
the quick channel selection mode will be enabled.
7. U (Up) Key
This key allows the selection of the operating channel in increments. By keeping this key pressed,
the quick channel selection mode will be enabled.
8. SQUELCH Control
The SQUELCH control allows the operator to silence the radio, blocking the background noise,
when no signals are received on the operating channel. Turn the SQUELCH knob clockwise until
the background noise stops. Turn the SQUELCH knob counterclockwise (SQUELCH opening) to
listen to the weakest signals. If this switch is turned off the Automatic Squlech Control will be
activated.
Page 4 o f14
Control & Operation
All manuals and user guides at all-guides.com

User Manual CM10
9. OFF / VOLUME Control
Use this knob to switch the radio ON and OFF, as well as to adjust the receiver volume to the
desired level. To adjust the receiver volume (if no signals are received on the operating channel),
open the SQUELCH and then adjust the receiver volume using the background noise as a
reference.
10. Microphone Connector
Insert the microphone lead to this connector and turn the connector ring in a clockwise to lock it.
Rear
11 12
13
11. EXT (External) Speaker Jack
This jack is for connecting an (optional) external speaker.
12. ANTENNA Connector
Please refer to the section ANTENNA INSTALLATION (page ).
13. 13.2VDC OWER CORD
Microphone
14. TT ( ush-to-Talk) Key
Transmitter key, press the PTT key to transmit and release to return to receive mode.
15. MICRO HONE lug
The 4-pin microphone connector (with locking ring), this connects the handset to the microphone
connector on the front panel of the radio.
Page 5 o f14
Control & Operation
All manuals and user guides at all-guides.com